Chief SLM190 Bruksanvisning
Chief
prosjektor tilbehør
SLM190
Les nedenfor 📖 manual på norsk for Chief SLM190 (1 sider) i kategorien prosjektor tilbehør. Denne guiden var nyttig for 3 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere
Side 1/1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8802-000259 Rev01
©2009 Milestone AV Technologies,
a Duchossois Group Company
05/09
SSB-190, SSM-190, SLB-190 and SLM-190 Interface Brackets
SSB-190, SSM-190, SLB-190 and SLM-190 Interface Brackets are designed for use with Chief® Series Projector Mounts. See the specific
installation instructions provided with the mount for additional installation information.
Unpack carton and verify kit contents. If any listed parts are missing, immediately contact a Chief Customer Service representative.
WARNING: IMPROPER INSTALLATION CAN LEAD TO EQUIPMENT FALLING CAUSING SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Use only hardware supplied by manufacturer!
Installation Instructions
WARNING: OVER TIGHTENING OF SCREWS CAN DAMAGE PARTS AND CAN LEAD TO SERIOUS PERSONAL INJURY AND
DAMAGE TO EQUPIMENT! DO NOT over tighten screws when installing interface brackets.
NOTE: Step 1 is only required when installing an SLB/SSB interface bracket. If an SLM/SSM bracket is being installed, proceed to step 2.
1. Screw thumb screws onto 10-24 x 5/8" Phillips pan head screws. DO NOT fully tighten thumb screws at this time.
2. Turn projector upside down on a flat surface.
3. Place the optional felt pads on the mount surface (as seen above) to protect projector paint.
4. Slide the front of the projector through the rear or the mount forward and align the 1/4" mounting hole in the projector with the 1/4" mounting
hole in the mount.
5. Place the 1/4" nylon spacer on the lamp door of the projector and slide it in between the projector and the 1/4" mounting hole in the mount.
6. Using the 1/4" - 20 x 5/8" long button head screw and 1/4" flat washer, place screw and washer through the bracket hole and nylon spacer,
and secure all using 5/32" hex key. Tighten all fasteners at this time, securing the bracket to the projector.
NOTE: Security screws can be substituted when mounting interface bracket to projector by using the parts and installation
instructions in the All-Points Security Kit.
Chief® is a registered trademark of Milestone AV Technologies. All rights reserved.
(1) Interface Bracket (1) Screw, Button Head Cap, 1/4-20 x 5/8"
(4) 10-24 Thumb Nuts ** (2) Washer, Flat, 1/4"
(1) All-Points Security Kit (1) Spacer, Nylon, .320 x 1/2" x 1/4"
(4) Pad, Felt
**Only used when installing SLB/SSB interface brackets.
NOTE: Specific to SSB-style and SSM-style interface bracket installation, all appropriate screws come pre-installed as reflected in the
encircled locations above. DO NOT attempt to substitute and USE ONLY this pre-installed hardware for SSB-style and SSM-style
interface bracket installation.
SLB-190 SLM-190
Lamp Opening
Lamp Opening
Felt Pad Location
Felt Pad Location
Towards front of
projector
Towards front of
projector
(Note: SSM-style interface bracket connection
s
a
r
e
e
n
c
i
r
c
l
e
d
)
(Note: SSB-style interface bracket connections
a
r
e
e
n
c
i
r
c
l
e
d
)
Produkspesifikasjoner
| Merke: | Chief |
| Kategori: | prosjektor tilbehør |
| Modell: | SLM190 |
| Pakkevekt: | 2000 g |
| Antall per pakke: | 1 stykker |
| Produktfarge: | Sort |
Trenger du hjelp?
Hvis du trenger hjelp med Chief SLM190 still et spørsmål nedenfor, og andre brukere vil svare deg
prosjektor tilbehør Chief Manualer
15 September 2025
15 September 2025
15 September 2025
15 September 2025
15 September 2025
15 September 2025
15 September 2025
14 September 2025
14 September 2025
14 September 2025
prosjektor tilbehør Manualer
- prosjektor tilbehør Optoma
- prosjektor tilbehør Viewsonic
- prosjektor tilbehør Chipolino
- prosjektor tilbehør BenQ
- prosjektor tilbehør Barco
- prosjektor tilbehør AV:link
Nyeste prosjektor tilbehør Manualer
27 August 2025
27 August 2025
16 August 2025
16 August 2025
16 August 2025
16 August 2025
16 August 2025
15 August 2025
15 August 2025
13 August 2025