Electro-Voice XLE191-FG Bruksanvisning
Electro-Voice
Høyttaler
XLE191-FG
Les nedenfor 📖 manual på norsk for Electro-Voice XLE191-FG (4 sider) i kategorien Høyttaler. Denne guiden var nyttig for 29 personer og ble vurdert med 4.2 stjerner i gjennomsnitt av 15 brukere
Side 1/4
X-Line Very Compact
Crossover Retrofit
Installation Instructions
YOU WILL NEED:
- ONE SHORT-HANDLED PHILLIPS SCREWDRIVER
- ONE SHORT-HANDLED ¼” NUT DRIVER
- SMALL SCRAPER OR PUTTY KNIFE
- SMALL WIRE (SIDE) CUTTER TO SNIP CABLE TIES
- CARPENTERS’ WOOD GLUE
- 3M SUPER 77 SPRAY ADHESIVE OR LIQUID
CONTACT CEMENT
1) REMOVE THE 6 SCREWS HOLDING THE INPUT PANEL. CAREFULLY UNPLUG THE MOLEX CONNECTOR
FOR THE TRANSDUCER WIRING AND PEEL OFF THE CONTACT INFORMATION LABEL COVERING THE
“BIAMP” INDICATOR WINDOW ON XLD OR “PASSIVE” INDICATOR WINDOW ON XLE.
2) REMOVE THE GRILLE.
3) REMOVE THE WOOFER THAT SHARES THE SAME CHAMBER AS THE INPUT PANEL.
4) STAND THE ENCLOSURE ON ONE END WITH THE NOW OPEN CHAMBER ON TOP. REMOVE THE BATTING
FROM THIS CHAMBER AND DISCARD.
5) USING THE ¼” NUT DRIVER, UNSCREW THE TWO CABLE TIES SECURING THE WIRES TO THE DIVIDER
PANEL. SAVE THE SCREWS.
6) CAREFULLY SNIP THROUGH THE CABLE TIES TO FREE THE WIRES FROM THEIR BUNDLE, TAKING CARE
NOT TO DAMAGE THE INSULATION ON THE WIRES.
7) SCRAPE OFF ANY EXCESS GLUE DRIBBLES, ADHESIVE AND LEFTOVER BATTING FROM THE SIDEWALLS
OF THIS CHAMBER, ESPECIALLY THE DIVIDER PANEL. TAKE CARE NOT TO ALLOW WIRING TO BE
DAMAGED BY YOUR SCRAPER BLADE. DO NOT DISTURB CAULKING MATERIAL IN WIRING THRU-HOLE
TO HF CHAMBER. IF YOU DO, IT MUST BE RE-SEALED WITH SILICONE RTV CAULK.
8) NOTE THE CHANNELS MILLED INTO ONE SIDE OF THE NEW MOUNTING BOARD. (THE SIDE WITH THE T-
NUTS SHOWING) APPLY AN EVEN LAYER OF WOOD GLUE TO THE FLAT AREAS ADJACENT TO THESE
CHANNELS. (SEE FIGURE 1)
Glue
Rounded Corner
Glue
Rounded Corner
Glue
000-649103 TSILSTRAPTIFORTERREVOSSORCE/DLX
N/P NOITPIRCSED .YTQ
000-080207 DRAOBGTMTIFORTERREVOXE/DLX 1
000-804065 E/DLX,REVOX 1
90883 NOLYN,TALF,REHSAW 7
PCL412706 8
/7X42-01,WERCS 7
31437 EITELBAC 1
000-126195 GNITTAB FL1
000-141185 WERCSLLAWYRD”¼1x8# 6
47401183 TIFORTERREVOXE/DLX,SNOI
TCURTSNI 1
This End of Mounting Board
to Rear of Enclosure
T-Nuts
Figure 1: Apply Glue to Mounting Board
Channel
Channel
Produkspesifikasjoner
| Merke: | Electro-Voice |
| Kategori: | Høyttaler |
| Modell: | XLE191-FG |
Trenger du hjelp?
Hvis du trenger hjelp med Electro-Voice XLE191-FG still et spørsmål nedenfor, og andre brukere vil svare deg
Høyttaler Electro-Voice Manualer
11 August 2025
11 August 2025
11 August 2025
11 August 2025
11 August 2025
11 August 2025
11 August 2025
11 August 2025
11 August 2025
11 August 2025
Høyttaler Manualer
- Ultimate Ears
- Triangle
- Sven
- Pyle
- NGS
- Lexibook
- Speco Technologies
- Klark Teknik
- Boompods
- Arcam
- Teufel
- Telefunken
- Xvive
- GoldenEar
- MEE Audio
Nyeste Høyttaler Manualer
23 Oktober 2025
21 Oktober 2025
21 Oktober 2025
20 Oktober 2025
20 Oktober 2025
20 Oktober 2025
20 Oktober 2025
20 Oktober 2025
20 Oktober 2025
20 Oktober 2025