GE JX1830SB Bruksanvisning

GE Magnetron JX1830SB

Les nedenfor 📖 manual på norsk for GE JX1830SB (4 sider) i kategorien Magnetron. Denne guiden var nyttig for 16 personer og ble vurdert med 4.8 stjerner i gjennomsnitt av 8.5 brukere

Side 1/4
PART QUANTITY
Trim Frame 1
Bottom Duct 1
Side Duct 1
1” Screws 6
(4 required, 2 extra)
1/2” Screws 15
(11 required, 4 extra)
Anti-Tip Bracket 1
Bottom Bracket 1
Upper Duct 1
Template 1
PARTS INCLUDED
Questions? Call GE Answer Center at 800.626.2000
or Visit our Website at:
www.GEAppliances.com
KEEP THESE INSTRUCTIONS
.
Installation Built-In Trim Kits
Instructions
JX1827 and JX1830
Read these instructions completely and carefully.
IMPORTANT
Save these
instructions for local inspector’s use.
IMPORTANT
Observe all
governing codes and ordinances.
Note to Installer
Be sure to leave these
instructions with the Consumer.
Note to Consumer
Keep these
instructions for future reference.
BEFORE YOU BEGIN
Unplug the microwave oven before attempting
installation of this kit.
Skill level Installation of this appliance requires basic
mechanical and electrical skills.
Completion time 1-3 hours
Proper installation is the responsibility of the installer.
Product failure due to improper installation is not
covered under the Warranty.
This kit is UL listed for installation alone or over any
General Electric/Hotpoint/RCA single electric wall
oven.
TOOLS YOU WILL NEED
Phillips screwdriver
Pencil
Tape measure
Awl or punch
Drill with
7
64bit or #35
1
FOR YOUR SAFETY:
WARNING
Before beginning the
installation, switch power off at service panel and lock
the service disconnecting means to prevent power
from being switched on accidentally. When the service
disconnecting means cannot be locked, securely fasten
a prominent warning device, such as a tag, to the
service panel.

Produkspesifikasjoner

Merke: GE
Kategori: Magnetron
Modell: JX1830SB

Trenger du hjelp?

Hvis du trenger hjelp med GE JX1830SB still et spørsmål nedenfor, og andre brukere vil svare deg