Godox Ring 48 Bruksanvisning

Godox lys Ring 48

Les nedenfor 📖 manual på norsk for Godox Ring 48 (2 sider) i kategorien lys. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/2
五、技术规格
有效
功率比
如使用 × 氢电池2 AA
尺寸
重量
3cm m-1.0 (1.1-40英寸)
半光、全光
使用时 小时1.5
电源控制器1
环形灯2
()×10.3(宽)× .8(深)12.8 2 cm
165g (无电池时)
48
5500K ~ 6500K
LED灯珠数
色温
环形灯头 1个
充电器 1个
电源控制器 1个
适配环(六种规格) 49mm 52mm 55mm 58mm 62mm 67mm
1 、使用时小心 免发生碰撞或落。
2、勿在温度过高低以及潮湿的环境下使用此灯。
3、勿使用稀剂、苯或其他清洁剂擦洗产品上的污或指印。可使用柔加湿的布
清洁。
4 ,LED、当光灯从温度低的室外移到温度较高的室内时 灯内会出现冷凝现
可损坏产品。此时 应等待灯到室温后 再使用。
5 、如不使用 应储存在干燥、凉、通风良好的地方。
为满市场上新的 我公司不断升级我们的产品。正因为如此 产品规格中
的某些最新变更有可能未包含在本使用明中。
六、套装配置
七、使用注意事项
四、使用方法:
(一)安装电源控制器
座插入相机上的热靴,动热靴锁将其紧。
(二)将环形 灯安装到相机LED
本产品有六种规格的适配环与相机圈相符 49mm 52mm
55mm 58mm 62mm 67mm、、和。
择相应的环安装在相机头上然后将灯头套在上面,即可将相机与灯头固
定好。
然后将灯头上的电源入插头插入电源控制器上的“ ”插孔。OUT PUT
(三)开始使用
择使用电池供电A
则装上电池在电源控制器上将开关拨动到“ ”位置。BATT
B择使用充电器供电
将充电器的圆形插头插到电源控制器的“ ”上另一头插上交流电DC3V
将电源控制器上的电源开关拨动到“ ”位置即可使用。DC3V
(四)镜头使用
虽然本微摄影光灯是特为微距镜设计可能与其他类型的头一使
用。不过,使用时注意以下几点
某些头在装上环形 灯后,调焦时头会,这样将影响到相机的LED
工作并有可能出现故
严禁使用专配的充电器给装在灯上的镍氢电池充电。
使用此类镜头时,请只使用手动调焦。
# 本产品因功率比较大,耗电需求大,因此强烈建议使用可充电电池。如果使用
普通的 电池,会因电池输出电流偏小而发光不够,并且使用时间不长。1.5V
# 此 灯耗电量比较大,不用的时候请及时关闭电源。LED
一、部件名称:
② 电源出插孔
③ 3 直流电源入插孔 V
④ 电源工作指示灯
⑤ 热
电池仓
本微环形 灯使用电源有 LED 2
1 2 AA、使用 碱性干电池或可充电氢电池。
2、使用专的充电器直接 供电。3V
(注意:此充电器仅作为 灯的电源使用,禁止当做可充电电池的充电器使用)LED
1、使用前将电池接端擦净 以保持良好接
2 AA、为免电池爆炸、液体泄漏或使用同一型号和品牌的两节新电池
将不同型号或新旧电池混在一使用。
3、勿拆开、短接电池或将其置于火中或者水中 以免发生爆炸。锂镉电池以
不对其他电池行充电。
4、如不使用此灯 应将电池取出。
⑥ 电源控制和用电模式控制开关
⑦ 充电器插头
⑧ 充电器 出插头3V
⑨ 灯头电源入插头
灯珠模式控制开关LED
二、电源:
三、使用电池注意事项:
微距环形 LED
使用说明书
48RING
LED
WWW. G O D OX . C O M
5. Specifications:
Effective Distance
Power Rate
Service Time
(2 AA Nickel-hydrogen Batteries)
Size
Weight
3cm 00cm inches-1 (1.1-40 )
Semi Power, Full Power
About 1.5 hours
Power Controller:
9.1*4.4*4.4 cm
Macro Ring Flash:
12.8*10.3*2.8 cm
165g (without batteries)
48 PCS
5500K ~ 6500K
LED
Color Temperature
1) Avoid clash or falling when used.
2) Do not use the flash in extreme high or cold temperature or in
dampness.
3) Do not clean the stains or fingerprint with thinner, benzene or other
detergents. Clean the light with soft wet cloth.
4) If the light comes from a colder room to a warmer room, condensation
will happen inside LED light and can damage the product. Do not use
the product until it reaches the room temperature.
5) Keep it in dry, cool place with good ventilation when not used.
We keep improving our products to meet the need of market, so
any subtle changes may not be updated in the manual Sorry for .
the inconvenience.
Macro ring head 1PC
Charger 1PC
Power controller 1PC
Adapter ring 6PCS (49mm 52mm 55mm 58mm 62mm and 67mm, , , , , )
6. Contents:
7. Notice:
Important notes
# Due to its high power consumption, we strongly recommend rechargeable
batteries. If common 1.5V battery is used, the light effect will be immer d
and the service time shorter.
# Turn off the power when the ring ight s not used due to the high power l i
consumption.
1 Power Controller Installation
Attach hot shoe onto the camera hot shoe mount and rotate to
tighten the hot shoe locker ring.
2 Installation of Macro Ring light head to the camera
6 types of adapter rings available to suit the camera lens 49mm : ,
52mm 55mm 58mm 62mm and 67mm, , , , .
3) How to Use
A. Power Supply By Battery
Install the battery and switch the power controller to BATT
B. Power Supply By Charger
Insert the round plug of charger into the DC3V of power controller' ' ,
and connect the other end with the AC power And then turn the .
power switch of power controller to DC3V ”.
Warning: Do not leave the rechargeable battery in the power
controller when it is being charged .
4) Lens Usage
Designed for Macro-lens, the LED light can be used with other types
of lens, but please take note the followings:
Some lens might turn after the installation of this LED ring ead, h
which may affect camera focusing. Please use manual focus when
apply this kinds of lens.
LED
4. Using Method:
1. Names of Principal Parts
Battery Pack
Power Output Jack
3V DC Power Input Jack
Power Indicator Lamp
Hot Shoe
Power and Power Mode Controller
: Off Power Off
3 : DC V Power Supply By Charger
: Batt Power Supply By Battery
2 ways of power supply are available for this Macro Ring light:
1) 2 AA alkaline dry batteries or rechargeable Ni-MH batteries.
2) Exclusive charger for 3V power supply.
Warning: This charger is only used for LED light Do not use it for.
the rechargeable battery
LED
2. Power Matters:
3. Attention:
1) Clean the ends of battery to make sure the good connection.
To avoid battery explosion fluid leakage or overheating please use the , ,
same model and brand new two AA batteries, not to mix old and new
batteries or different models for use .
2) Do not dismantle or drain batteries or put batteries in water or fire,
which may cause explosion. Do not charge the batteries except
lithium and cadmium cell.
3) Remove the batteries if you don t use the lamp for a long time. '
Charger Input Plug
Charger 3V Output Plug
Ring Head Power Input Plug
LED Mode Controller
48RING
Macro LED Ring Light
Instruction Manual
Macro LED Ring Light
WWW.GODOX.COM

Produkspesifikasjoner

Merke: Godox
Kategori: lys
Modell: Ring 48

Trenger du hjelp?

Hvis du trenger hjelp med Godox Ring 48 still et spørsmål nedenfor, og andre brukere vil svare deg