Adam Hall SLT001 Bruksanvisning

Adam Hall DJ-utstyr SLT001

Les nedenfor 📖 manual på norsk for Adam Hall SLT001 (2 sider) i kategorien DJ-utstyr. Denne guiden var nyttig for 6 personer og ble vurdert med 4.6 stjerner i gjennomsnitt av 3.5 brukere

Last ned PDF

Side 1/2

BEDIENUNGSANLEITUNG

USER´S MANUAL MANUEL D´UTILISATIONI

SLT001 / SLT001W MULTI-PURPOSE LAPTOP STAND

PARTS

Adam Hall GmbH · Daimlerstr. 9 61267 Neu-Anspach Germany

Tel.: (+49) 60 81 / 94 19 0 Fax.: (+49) 60 81 /94 19 1000 e-mail: mail@adamhall.com

1. Take one of the upper supports and place it over the outside of one of the lower supports (see ﬁgure A). Align the upper support holes with the

lower support mounting holes to obtain the desired height.

2. Place one knob at a time through the mounting holes (must be spaced at least 2 holes apart).

3. Take a stabilizer bar and screw the top knob into the end of the stabilizer bar. Repeat with bottom knob.

4. Install 1 inch spacers on each stabilizer bar to increase stand width. Repeat step 3 with the other upper support and lower support for the opposite

side of the stand (see Figure B). Secure all knobs tight to minimize stand wobble.

Table top assembly

1. Attach ﬂat foot bar to lower support

with two (2) A-screws and washers

(see ﬁgure C).

2. Repeat above with the other lower

support for the opposite side of the

stand.

Table C-clamp assembly

1. Turn clamp with knobs facing down

and attach to lower support with two

(2) B-screws and B-washers (see