ATM Cool-rack III Bruksanvisning
Les nedenfor 📖 manual på norsk for ATM Cool-rack III (3 sider) i kategorien Skap. Denne guiden var nyttig for 23 personer og ble vurdert med 5.0 stjerner i gjennomsnitt av 12 brukere
Side 1/3
Acti
Acti
Acti
ActiActive T
ve T
ve T
ve Tve Therm
herm
herm
hermhermal
al
al
al al Man
Man
Man
ManManage
age
age
ageagemen
men
men
menment
t
t
t t
The trusted name in thermal protection
Instructions for installation of the Cool-rack III
The Cool-rack III can be mounted on the front or rear rails of most equipment
racks. An opening for air to enter the rack must be provided to ensure maximum
cooling. The best arrangement positions the air inlet such that cool room air
enters the rack at a low point and "washes" over the heated equipment on its way
to the fans. A small display on the control board mounted on the back of the Cool-
rack III is meant for set-up only. It reads in degrees Celsius, not Fahrenheit, and
will not be visible after installation
The Coo
The Coo
The Coo
The CooThe Cool-rack III is not for u
l-rack III is not for u
l-rack III is not for u
l-rack III is not for ul-rack III is not for use in racks with f
se in racks with f
se in racks with f
se in racks with fse in racks with front doors, which
ront doors, which
ront doors, which
ront doors, which ront doors, which would block
would block
would block
would block would block
airflow.
airflow.
airflow.
airflow. airflow. Use the rear rack rai
Use the rear rack rai
Use the rear rack rai
Use the rear rack raiUse the rear rack rails for moun
ls for moun
ls for moun
ls for mounls for mounting the Cool-rack
ting the Cool-rack
ting the Cool-rack
ting the Cool-rackting the Cool-rack II, if possible. (A
II, if possible. (A
II, if possible. (A
II, if possible. (A II, if possible. (ATM
TM
TM
TM TM
makes se
makes se
makes se
makes semakes several cooling systems
veral cooling systems
veral cooling systems
veral cooling systems veral cooling systems designed sp
designed sp
designed sp
designed spdesigned specifically
ecifically
ecifically
ecifically ecifically for racks with doors
for racks with doors
for racks with doors
for racks with doors for racks with doors or
or
or
or or
racks loca
racks loca
racks loca
racks locaracks located in cabinets
ted in cabinets
ted in cabinets
ted in cabinets ted in cabinets or closets.
or closets.
or closets.
or closets. or closets.
Be careful not to damage the exposed temperature control printed circuit board
mounted behind the fan panel. After mounting the panel in the rack, connect the
output lead from the power supply to the power jack attached to the control
board, and run the thermistor to the vicinity of the hottest area within the rack.
The thermistor can be fastened using the adhesive-backed anchor supplied.
Direct connection to the heat source will cause the fans to come on sooner than a
less-direct connection, such as suspending it over, rather than on, a hot
component.
Plug the power supply into an always-live AC source. When the temperature at
the thermistor reaches approximately 90F/32C degrees, the fans will begin to
turn. The fans will stop when the temperature falls below approximately 85F/29C.
A hair dryer can be used to check for proper operation.
To change the temperature at which the fans turn ON, press the SET button on
the control board momentarily. The display will blink. Press the or buttons to ▼ ▲
change to the desired temperature. After a few seconds, the new temperature will
be stored.
To change the temperature at which the fans turn OFF, decide how many
degrees below the turn-on temperature you wish the fans to stop, called the
Produkspesifikasjoner
| Merke: | ATM |
| Kategori: | Skap |
| Modell: | Cool-rack III |
Trenger du hjelp?
Hvis du trenger hjelp med ATM Cool-rack III still et spørsmål nedenfor, og andre brukere vil svare deg
Skap ATM Manualer
9 April 2025
9 April 2025
9 April 2025
Skap Manualer
- Yamazen
- Ryobi
- Stanley
- Sanus
- Gude
- Hygena
- Royal Catering
- Paidi
- Tripp Lite
- Livarno Lux
- Butler
- SereneLife
- Step2
- Apc
- Kanto
Nyeste Skap Manualer
13 Oktober 2025
12 Oktober 2025
11 Oktober 2025
11 Oktober 2025
11 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025
10 Oktober 2025