AXESS AXDCT-2 Bruksanvisning

Les nedenfor 📖 manual på norsk for AXESS AXDCT-2 (3 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 16 personer og ble vurdert med 3.7 stjerner i gjennomsnitt av 8.5 brukere

Side 1/3
AXDCT-2
INSTALL ATION INSTRUCT IONS
REV. 3/2/20
© COPYRIGHT 2020 METRA ELECTRONICS CORPORATION
Integrate • AxxessInterfaces.com
The AXDCT-2 should be installed on a stereo’s speaker output wires or the
output wires on an factory amplifier of up to 80 watts per channel. These
wires can be found behind the stereo in the dash, on the outside of an factory
amplifier, or on the input terminals on the factory speakers.
stereo applications as follows:
Yellow - Battery +12v input †
Black - Ground input †
Blue - Remote +12v output †
These wires can be connected directly to the amplifier being installed.
Wires only required if a 12v amp turn-on is desired.
White - Left front (+) input
White/Black - Left front (-) input
Gray - Right front (+) input
Gray/Black - Right front (-) input
Black/White - Reference ground (-)
(Reference ground optional if noise is present)
Note: Be sure that all audio input connections are polarized or in phase with
each other. That is, the positive output wires from the audio source need to be
connected to the corresponding positive input wires of the AXDCT-2. The same
goes for the negative audio wires. Failure to do this will result in poor bass
response and low quality audio.

Produkspesifikasjoner

Merke: AXESS
Kategori: Ikke kategorisert
Modell: AXDCT-2

Trenger du hjelp?

Hvis du trenger hjelp med AXESS AXDCT-2 still et spørsmål nedenfor, og andre brukere vil svare deg