Dual MRF40 Bruksanvisning

Les nedenfor 📖 manual på norsk for Dual MRF40 (8 sider) i kategorien Fjernkontroll. Denne guiden var nyttig for 3 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/8
MRF40
Marine
RF
Remote
Control
Installation
and
Owner·s
Manual
MRF40
Installation
Installing
the
MRF40
receiver
1.
Connect the 3.5mm cable
to
the
REMOTE
IN
input
on
the back of the radio.
2. Connect the black wire from the
MRF40
receiver to a good ground (-)
source. Typically. the ground wire connection from the radio wiring
harness
can
be
used.
3. Connect the red wire from the
MRF40
receiver to a
12
volt accessory
switched power source. This may
be
connected
to
the red accessory
power wire at the radio wiring harness.
Note:
The wiring
can
be
extended up
to
20
feet
if
required. A standard 3.5mm
extension cable
can
be
used
to
extend the
REMOTE
IN
3.5mm connector. but
depending
on
the quality of the wiring. performance may
be
affected. Always
test any wiring extensions to ensure proper performance from the
RF
remote
control before performing the installation.
See
illustration below for connection details.
Red
Wire(+)
Connect
to
a
switc!Md
.ccessory
12-volt
power
aource
Black
Wire
(-)
Connect
to
a
chassis
or
battery
ground
aource
3.
5mm
Cable
Connect
to
the
RF
REMOTE
IN
at
the
back
of
the
radio
2

Produkspesifikasjoner

Merke: Dual
Kategori: Fjernkontroll
Modell: MRF40

Trenger du hjelp?

Hvis du trenger hjelp med Dual MRF40 still et spørsmål nedenfor, og andre brukere vil svare deg