Extron SMP 401 Bruksanvisning
Extron
Ikke kategorisert
SMP 401
Les nedenfor 📖 manual på norsk for Extron SMP 401 (4 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 11 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 6 brukere
Side 1/4
1
SMK F SF 10C Plus Kit • Setup Guide
This guide provides instructions for an experienced installer to install the Extron SMK F SF 10C Plus
oor mount kit for the SF 10C SUB subwoofer. The SMK F SF 10C Plus kit consists of four long legs
for mounting the speaker vertically, and four short legs for mounting the speaker horizontally. Each
kit includes 12 screws and locking nuts, and 24 washers.
NOTE: See the or for detailed instructions regarding the SF 10C SUB subwoofer.SF 10C SUB User Guide SF 10C SUB Setup Guide
ATTENTION:
• The SF 10C SUB must have rebreaks installed in the wall, above and below it, when it is protruding through a wall, to meet UL
requirements.
• Le SF 10C SUB doit disposer de systèmes coupe-feu installés au mur, au-dessus et au-dessous de l’unité, lorsqu’elle est placée
en saillie du mur, an de satisfaire les exigences de l’UL.
• The subwoofer must be securely fastened to the stud or other stationary surface when mounted in one of the vertical positions.
• Le caisson de grave doit être solidement xé au montant ou à une autre surface stationnaire lorsqu’il est monté dans l’une des
positions verticales.
NOTES:
• Remember that the sound from the unit is directed out the port. Therefore, the port needs to be pointed into the listening space.
• To ensure that the Extron grille ts fully into any masking wall or other partition, the center of the port tube must be at least
5-3/16 inches (132 mm) from the edge of the wall.
• The grille does not t if you install the legs on the subwoofer with the port tube down. Consider fabricating a small platform to lift
the subwoofer (see on the next page), or otherwise design your own way to dress your installation to give it a nished figure 2
look.
• Steps 3, 4, 5, and 8 are necessary only if you are installing the subwoofer in an adjoining space.
Installing Long Legs for Vertical Installation
The subwoofer can be set vertically on a oor using the included long legs as follows:
1. Determine where the subwoofer is to be placed and its orientation (port tube on top or port tube on the bottom).
2. Remove the grommets from the holes in the installation bracket.
3. Fasten two legs to each installation bracket using the three provided screws and locking nuts, two on one side of the foot (see
figure 1, 1) and one on the other side (2).
1221
Figure 1. Long Leg Installation
IMPORTANT:
Go to www.extron.com for the complete
user guide, installation instructions, and
specifications before connecting the
product to the power source.
Produkspesifikasjoner
| Merke: | Extron |
| Kategori: | Ikke kategorisert |
| Modell: | SMP 401 |
Trenger du hjelp?
Hvis du trenger hjelp med Extron SMP 401 still et spørsmål nedenfor, og andre brukere vil svare deg
Ikke kategorisert Extron Manualer
3 April 2025
3 April 2025
3 April 2025
3 April 2025
12 Mars 2025
11 Mars 2025
25 Februar 2025
25 Februar 2025
25 Februar 2025
25 Februar 2025
Ikke kategorisert Manualer
- Audient
- J5create
- CaviLock
- Generac
- Kask
- Sunny
- Polyend
- Thorens
- Neno
- Stalco
- Coca-Cola
- Blaupunkt
- Exibel
- SureFire
- Laine
Nyeste Ikke kategorisert Manualer
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025