Hoffman F88WP Bruksanvisning

Les nedenfor 📖 manual på norsk for Hoffman F88WP (12 sider) i kategorien Kabler for PC og periferiutstyr. Denne guiden var nyttig for 19 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/12
Feed Through Wireway
Feed Through Kabelkanal
Chemin de câbles grande étanchéité
Ducto De Vidrio Con Brida Cerrada
87565317
Rev. B 113357 P/N 99401616E 2005 Hoffman Enclosures Inc.
®
E 2005 Hoffman Enclosures Inc.
2 87565317
INCRÉMENT
ÍNDICE
CONTENT PAGES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
INHALT SEITEN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CONTENUE PAGES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
CONTENIDO PÁGINA. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
English Instructions 35. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Deutsche Anleitung 68. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Instructions français 911. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Español Instrucciones 1214. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
87565317 3
E 2005 Hoffman Enclosures Inc.
1ENGLISH
Installation Instructions
FeedThrough Wireway
I. FINISH: The standard finish on this wireway is gray polyester powder over a cleaned and phosphatized surface. This
surface may be further finished with lacquer or enamel.
II. ASSEMBLY: To assemble most wireway sections and
fittings, simply place a gasket between
flanges and install screws and nuts as
shown in detail 1.
III. TELESCOPE FITTING:
A. To Adjust Telescope Fitting:
1. Assemble parts on body of telescope fitting in correct order as shown in detail 2.
2. Insert body of telescope fitting into straight section and adjust to the desired length.
3. Position gasket retainer against flange of straight section and force the gasket inside the gasket retainer
and against the flange.
4. Position compression ring against gasket retainer and install screws and nuts as shown in detail 3.
5. If wireway is to be used as ground, provisions must be made for grounding continuity across telescope fitting.
B. To Anchor Telescope Fitting at Desired Extension:
1. If the telescope fitting is used in a vertical position to support the wireway above, or if the telescope fitting
is otherwise subjected to a material axial load, means to support such a load may be provided by one of
two methods:
Method I: With the telescope fitting at the desired
extension, drill .25 inch diameter holes through each
side of the straight section and through the
telescope fitting. Install .25 20x.5 screws through
the holes from the outside and install cap nuts and
lockwashers as shown in detail 4.
Method II: Replace screws in two diagonally
opposite corners of flanges with .2520 threaded
rods. Assemble rods, nuts, and washers as shown
in detail 5. After tightening the nuts, measure the
length of the extension to be sure it is the same on
both sides.
Flange Gasket
Wireway
Sections
Detail 1
Gasket
Detail 3
Gasket Retainer
Detail 2
Gasket
Compression Ring
Body
Straight Section
Detail 4
Straight Section
Anchoring Screws
Telescope Fitting
(Nuts and lockwashers
are on inside)
Detail 5
Telescope Fitting
Lockwashers
And Nuts
Straight
Section
.2520 Threaded
Rods

Produkspesifikasjoner

Merke: Hoffman
Kategori: Kabler for PC og periferiutstyr
Modell: F88WP

Trenger du hjelp?

Hvis du trenger hjelp med Hoffman F88WP still et spørsmål nedenfor, og andre brukere vil svare deg




Kabler for PC og periferiutstyr Hoffman Manualer

Kabler for PC og periferiutstyr Manualer

Nyeste Kabler for PC og periferiutstyr Manualer