Intermatic PF1222TB1 Bruksanvisning
Intermatic
Ikke kategorisert
PF1222TB1
Les nedenfor 📖 manual på norsk for Intermatic PF1222TB1 (4 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 24 personer og ble vurdert med 5.0 stjerner i gjennomsnitt av 12.5 brukere
Side 1/4
MODEL: PF1222TB1 SUBPANEL
TWO CIRCUIT POOL EQUIPMENT CONTROL WITH FREEZE AND HEATER PROTECTION
IN INDOOR/OUTDOOR ENCLOSURE
PANEL RATING: 60 AMP. 120/240 VOLT, 607 HZ.
This Pool Equipment Control is designed to automatically operate the Filter Pump, Cleaner Pump and also to provide
freeze protection for the pool equipment. Nevertheless this product is not intended to be a substitute for insulation,
coverings, or maintenance.
THE FILTER PUMP TIME SWITCH is located in the upper
left side of the enclosure and operates the Filter Pump, as
set by the trippers on the yellow dial, on a 24 hour
schedule. For setting the schedule, refer to page 3 of this
Manual.
THE FIREMAN SWITCH (heater protection mechanism) is
located next to the manual lever and its function is to stop
the heating process 20 minutes before the Time Switch
turns OFF the Filter Pump. By doing so, the circulating
water cools the heat exchanger thus preventing excess
heat build-up.
THE CLEANER PUMP TIME SWITCH is located in the
upper right side of the enclosure and operates the Cleaner
Pump (Booster Pump). The trippers of this Time Switch
should be set so that the operation of the Cleaner Pump
falls within the operation of the Filter Pump. To avoid
equipment damage, the two Time Switches are interlocked
and the Cleaner Pump would not operate unless the Filter
Pump is already operating.
THE FREEZE PROTECTION THERMOSTAT is located in
the lower left side of the enclosure and turns ON the Filter
Pump when the air temperature (where the Control Panel
is located) drops below the temperature set by the dial
(between 33˚F and 42˚F).
INSTALLATION
OPERATION &
SERVICE MANUAL
PF1000 SERIES
FREEZE PROTECTION CONTROLS
Risk of drowning!
Do not permit unsupervised children to use pool or spa.
Close supervision of children required at all times.
DANGER
Turn power off at main panel before servicing this switch or the equipment it controls. This control panel must be
installed according to the National Electrical Code and local code requirements. Use MIN 75˚C Copper conductors ONLY.
Install interchangeable circuit breakers with an interrupting current rating of 10000 symmetrical amperes, or higher.
Follow manufacturers instructions for installing and testing of ground fault circuit breakers (GFCB) and interrupters
(GFCI). Install only LISTED receptacle(s) and/or wiring device(s) inside the enclosure. When panel is outdoors, a LISTED
rainproof cover must be installed over the wiring device in the side knockouts. This control should not be connected
to any equipment which would cause bodily injury or property damage should it be activated unexpectedly.
Reinstall safety guard after wiring.
WARNING
Risk of Fire or Electrical Shock
GENERAL INFORMATION
Produkspesifikasjoner
| Merke: | Intermatic |
| Kategori: | Ikke kategorisert |
| Modell: | PF1222TB1 |
Trenger du hjelp?
Hvis du trenger hjelp med Intermatic PF1222TB1 still et spørsmål nedenfor, og andre brukere vil svare deg
Ikke kategorisert Intermatic Manualer
9 September 2025
25 August 2025
24 August 2025
24 August 2025
4 August 2025
8 April 2025
8 April 2025
8 April 2025
8 April 2025
8 April 2025
Ikke kategorisert Manualer
- Vent-A-Hood
- Guzzanti
- Consul
- Kerbl
- Cylinda
- Denon
- Plasma Cloud
- Helix
- Celexon
- Pressalit
- Randell
- Izzy
- Nethix
- JLab
- Overmax
Nyeste Ikke kategorisert Manualer
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025
23 Oktober 2025