Krowne BC36 Bruksanvisning

Les nedenfor 📖 manual på norsk for Krowne BC36 (28 sider) i kategorien Kjøleskap. Denne guiden var nyttig for 2 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/28
Due to our commitment to continued product improvement, specications are subject to change without notice. No. REF MANUAL
Krowne • 100 Haul Rd. Wayne, NJ 07470 • P: (800) 631-0442 • F: (973) 872-1129 • support@krowne.com • krowne.com
For Commercial Use Only. Not Residential.
Refrigeration
Installation & Operating Manual
2 Krowne • 100 Haul Rd. Wayne, NJ 07470 • krowne.com
Refrigeration Installation & Operating Manual
Installation ............................................................................. 3
Operating Temperature and Defrosting .............................. 3
Thermostat.............................................................................. 4
Cleaning Instructions ............................................................ 4
Safety Notices ....................................................................... 4
Specifications .................................................................... 5-6
Wire Diagrams .................................................................. 7-8
Replacement Parts: Compressor Housing ........................... 9
Replacement Parts: Locks, Handles, & Doors ..............10-11
Replacement Parts: Mechanical & Lighting ...................... 12
Replacement Parts: Temperature Control .......................... 13
Replacement Parts: Shelving .............................................. 14
Direct Draw Coolers Parts & Accessories ......................... 15
Legs, Casters, Accessories..................................................16
Troubleshooting ................................................................... 17
Changing a Door Handle .................................................. 18
Changing a Stainless Steel Top ......................................... 19
Installing a New Stainless Steel Top ..................................20
Changing a Swing Door .................................................... 21
Changing a Sliding Door ................................................... 21
Changing LED Lights ........................................................... 22
Adjusting Shelving ..............................................................22
Installing Dispensing Faucets .............................................23
Installing Dispensing Towers ..............................................24
Warranty .............................................................................25
Terms ....................................................................................26
Notes ...................................................................................27
Table of Contents
Need replacement parts?
Refrigeration replacement parts available for all units.
Natural
Refrigerant
Natural Refrigerant
Hydrocarbon refrigerants are natural, nontoxic refrigerants
that are one of the most climate-friendly and cost-efcient
refrigerants with no ozone depleting properties.
partsbykrowne.com
3Krowne • 100 Haul Rd. Wayne, NJ 07470 • krowne.com
Refrigeration Installation & Operating Manual
Installation
Operating Temperature & Defrosting
SELF-CONTAINED UNITS:
Digital thermostat can be found on the front condensing unit cover. To set to desired temperature, follow the steps below.
1. Press SET for 1 second. The set value will start flashing after a few moments
2. Increase or decrease the value using UP or DOWN
3. Press SET to confirm new value
Manual defrost cycle: Press DOWN for more than 3 seconds
The operating temperature for the Self-Contained Back Bar Cooler is preset at the factory for an average of 35°F.
Average operating range is from 29°F to 38°F.
Remote units need to be set by a certified refrigeration technician.
CAUTION:
This temperature is only a set point. If set to 32°F, product will not be 32°F and air temperature inside unit will not be 32°F.
Operating temperature/average temperature is usually 4°F to 5°F above set temperature.
Inspection Upon Receipt
Remove all shipping material from unit before operation.
Please inspect the unit for any hidden freight damage and
report any damage immediately to Krowne Metal Corp.
If included, install optional casters or legs to bottom of
unit. Please avoid turning unit on its side or rear to install
accessories. If this cannot be avoided, unit must be left in
the upright position for 24 hours before operating. All units
come equipped with predetermined mounting holes and self
starting bolts for easy install (bolts are provided only when
casters or legs are ordered from factory). It is important
to check that casters or legs are securely attached with
appropriate mounting hardware.
Electrical Requirements
115 Volt AC, 1 Phase, 60Hz. We recommend using a
dedicated 15 amp circuit minimum. 8’-0” grounded
cord standard on Self Contained Back Bar Coolers, Bottle
Coolers and Mug Frosters. Remote units come with a
terminal block inside the box for a hard wire connection
(supplied by the end user).
Plumbing
Self-Contained Back Bar Coolers have an evaporating pan
and do not require any plumbing hook-up. Remote units
require a drain hook-up. We recommend using 1/2” tubing
and running it through the same knockout used for the
refrigeration hook-up.
At Krowne Metal Corporation we are dedicated to customer satisfaction. This installation guide is provided to clarify and
answer any questions you may have regarding our line of Commercial Refrigerators. Please read this guide before attempting
installation or operation. Thank you for choosing Krowne as your refrigeration provider.
Installing of Shelves (Back Bar Coolers)
Shelves and installation clips are shipped within the cooler.
Shelves can be installed based on owner’s preference.
Location
Place unit in desired location and level. It is important for
the unit to be level, or it will not drain properly, and the
doors will not close properly, which in turn will affect the
function of the cooler and void any factory warranty. Allow
2” clearance for Back Bar Coolers in the back. If unit is being
installed directly to the oor, without legs or casters, the
equipment is required to be sealed to the oor or counter
to establish proper sanitary operation.It is recommended to
be sealed to the oor using an NSF certied silicone sealer.
The intended purpose of sealing equipment to the oor is to
prevent liquid spillage passing under inaccessible portions
of the equipment and to maintain the equipment’s NSF
sanitation certication. DO NOT BLOCK OR OBSTRUCT
FRONT GRILL. THIS EQUIPMENT IS INTENDED FOR
USE IN AN AREA WHERE THE AMBIENT TEMPERATURE
TYPICALLY DOES NOT EXCEED 75°F (24°C).

Produkspesifikasjoner

Merke: Krowne
Kategori: Kjøleskap
Modell: BC36

Trenger du hjelp?

Hvis du trenger hjelp med Krowne BC36 still et spørsmål nedenfor, og andre brukere vil svare deg




Kjøleskap Krowne Manualer

Kjøleskap Manualer

Nyeste Kjøleskap Manualer