Lewitt LCT 940 Bruksanvisning
Les nedenfor 📖 manual på norsk for Lewitt LCT 940 (2 sider) i kategorien Mikrofon. Denne guiden var nyttig for 43 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere
Side 1/2
// LCT 940
QUICKSTART GUIDE
TUBE // FET
AND EVERYTHING IN BETWEEN
LARGE DIAPHRAGM FET AND TUBE MICROPHONE
IN A SINGLE HOUSING
// Overview
// Large diaphragm condenser Tube & FET microphone
in a single housing
// Continuously blend between tube and FET sound via rotating
potentiometer
// Multi-pattern microphone: cardioid, omnidirectional, gure-8,
wide cardioid, supercardioid and four intermediate patterns
// Noiseless pushbuttons for quick and easy attenuation and
low-cut lter selection
// 4 low-cut settings: linear, 40 Hz (12 dB/oct), 150 Hz (6 dB/oct)
and 300 Hz (6 dB/oct)
// 4 pre-attenuation settings: 0 dB, -6 dB, -12 dB and -18 dB
// High dynamic range and low self-noise
// Custom power supply unit with illuminated user interface for easy
handling - even in dark environments
// Gold plated & corrosion-resistant 11-pin XLR socket
Top applications // Vocals, acoustic instruments
and wind instruments
// User interface
1 On/Off switch
2 Fuse
3 Mains socket
4 Mains voltage selection switch
5 3-pin XLR socket
6 11-pin XLR socket
7 Pre-attenuation indications
8 Pre-attenuation push button
9 Stageless ampli cation selection, rotary knob
10 Status indicator rings
11 Polar pattern selection, jog dial
12 Low-cut lter indications
13 Low-cut lter push button
14 11-pin audio cable
4
1
10
12
13
7
8
5 6
3
2
9 11
14
READ THE
FULL MANUAL!
Learn Everything about your LCT 940
www.lewitt-audio.com/resources/manuals/LCT-940.pdf
Supply voltage: Custom power supply unit 230 V, 50 Hz 110 V, 60 Hz
Current consumption: 14.95 W
Connector: Gold plated 11-pin XLR
Cable: 5 m (16.40 ft) 11-pin audio cable oxygen-free copper
// LCT 940
QUICKSTART GUIDE
// Operating the microphone
Status indicator rings 10
Illuminated in : The microphone is in normal working mode. white
Illumination is : Key-lock active. off
Illumination : The microphone is experiencing clipping due to high SPL. ashes in red
Illumination in : The microphone is in automatic attenuation mode. red
Illumination : The microphone indicates the clipping history.ashes in white and red
Blend between TUBE and FET sound // Turn the rotary knob 9 and select the desired amplication. Choose between clean
“FET” and warm “TUBE” amplication or a mixture of the two circuits. The amplication mix is indicated by the red dot around
the rotary knob.
Polar pattern indicator // The currently active polar pattern is illuminated in white. If an intermediate polar pattern is selected the
neighboring polar patterns are illuminated in red and a white dot is illuminated between.
9 different characteristics can be set by briey turning the jog-dial 11 to the right or left.
Setting a low-cut lter // Low-cut lters can be set by pressing the right push button 13 .
Settings are: linear, 40 Hz (12 dB/oct), 150 Hz (6 dB/oct) and 300 Hz (6 dB/oct). Low-cut lters eliminate unwanted low-frequency
sounds, compensate the proximity effect and reduce structure-borne noise. Do not forget to use the supplied windshield if
necessary.
Setting an attenuation level // Attenuation levels can be set by briey pressing the left push button 8 .
Settings are: 0 dB, -6 dB, -12 dB and -18 dB. Attenuation is used in high SPL environments in order to prevent clipping of the
microphone, mixer and other audio equipment.
To learn about the key-lock function clipping history, and automatic attenuation please read the full manual following the
link at the bottom.
// Please Note
// The capsule is a sensitive, high precision component. Make sure you do not drop it from high heights and avoid strong mechanical stress and force.
// To ensure high sensitivity and best sound reproduction of the microphone, avoid exposing it to moisture, dust or extreme temperatures.
Use supplied windshield if suitable.
// Do not apply excessive force on the buttons or the connected cable.
// When disconnecting the microphone cable, grasp the connector and do not pull the cable.
// Do not attempt to modify or x the microphone, as it would void your product warranty.
// The casing of the microphone can be cleaned easily using a wet cloth, never use alcohol or another solvent for cleaning.
// The windshield can be washed with soap water, if necessary.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
// Getting started
1 Make sure the mains voltage selection switch is set to the correct position depending on the country‘s mains electricity. 4
2 Use the 11-pin audio cable to connect the microphone with the 11-pin XLR socket on the backside of the PSU.
3 Use the 3-pin XLR cable to connect your mixer with the 3-pin XLR socket 5 on the backside of the PSU.
4 Put the LCT 940 into operation by activating the On/Off switch on the backside of the PSU.1
5 Let the tube warm up. Microphone reaches full sensitivity after 60 seconds.
6 Experiment with different Tube and FET ratios.
7 You are ready to go!
LEWITT
®
Burggasse 79
1070 Vienna
Austria
www.lewitt-audio.com
// IMPORTANT NOTICE!
// Never remove the mains earth, doing so can have lethal consequences.
// Replace fuse only with the same type.
// Only use indoors, in safe and dry environments.
// There are no user-serviceable parts inside the power supply unit, but there
are potentially lethal voltages. If it does not work correctly, you should consult your dealer. Do not open the unit yourself.
// Do not disconnect the microphone cable while the system is powered as this may result in damage to the microphone.
// Do not use with damaged cables or after unit has fallen and loose parts or broken glass can be heard inside.
// Do not cover the power supply unit, always leave enough space around it for proper ventilation.
Produkspesifikasjoner
| Merke: | Lewitt |
| Kategori: | Mikrofon |
| Modell: | LCT 940 |
Trenger du hjelp?
Hvis du trenger hjelp med Lewitt LCT 940 still et spørsmål nedenfor, og andre brukere vil svare deg
Mikrofon Lewitt Manualer
28 Desember 2024
16 Oktober 2024
Mikrofon Manualer
- Mikrofon Insignia
- Mikrofon Power Dynamics
- Mikrofon Vonyx
- Mikrofon Akg
- Mikrofon Neewer
- Mikrofon Philips
- Mikrofon Krom
- Mikrofon Godox
- Mikrofon Razer
- Mikrofon DJI
- Mikrofon Behringer
- Mikrofon Sony
- Mikrofon Yamaha
- Mikrofon Asus
- Mikrofon BOYA
- Mikrofon Audio-Technica
- Mikrofon Toa
- Mikrofon Pyle
- Mikrofon Shure
- Mikrofon Roland
- Mikrofon Auna
- Mikrofon Kenwood
- Mikrofon Zoom
- Mikrofon Sennheiser
- Mikrofon Elgato
- Mikrofon Artsound
- Mikrofon Røde
- Mikrofon Valcom
- Mikrofon Majority
- Mikrofon Genesis
- Mikrofon MXL
- Mikrofon Rolls
- Mikrofon Karma
- Mikrofon Glemm
- Mikrofon Speed-Link
- Mikrofon SPL
- Mikrofon Isovox
- Mikrofon Xvive
- Mikrofon Antelope Audio
- Mikrofon Vaddio
- Mikrofon Audix
- Mikrofon Omnitronic
- Mikrofon SE Electronics
- Mikrofon Electro-Voice
- Mikrofon Atlas Sound
- Mikrofon Comica
- Mikrofon Point Source Audio
- Mikrofon Vicoustic
- Mikrofon Mad Dog
- Mikrofon Lectrosonics
- Mikrofon Samson
- Mikrofon TC Helicon
- Mikrofon Triton
- Mikrofon PureLink
- Mikrofon TeachLogic
- Mikrofon NGS
- Mikrofon Auray
- Mikrofon Easypix
- Mikrofon Vimar
- Mikrofon Bogen
- Mikrofon Vocopro
- Mikrofon Galaxy Audio
- Mikrofon Atlas
- Mikrofon IK Multimedia
- Mikrofon HyperX
- Mikrofon DAP Audio
- Mikrofon Kopul
- Mikrofon Earthworks
- Mikrofon DPA
- Mikrofon Anywhere Cart
- Mikrofon Movo
- Mikrofon Sescom
- Mikrofon Sonic Presence
- Mikrofon Sontronics
- Mikrofon Chandler
- Mikrofon Universal Audio
- Mikrofon United
- Mikrofon Alfatron
- Mikrofon Tonsil
- Mikrofon Easyrig
- Mikrofon Steelseries
- Mikrofon Royer Labs
- Mikrofon Polsen
- Mikrofon Warm Audio
- Mikrofon Rode
- Mikrofon AEA
- Mikrofon Hohem
- Mikrofon Deity
- Mikrofon Synco
- Mikrofon LD Systems
- Mikrofon AVMATRIX
- Mikrofon CAD Audio
- Mikrofon Senal
- Mikrofon Phonic
- Mikrofon Ultimate Support
- Mikrofon ClearOne
- Mikrofon Antelope
- Mikrofon Voice Technologies
- Mikrofon KeepOut
- Mikrofon Neumann
- Mikrofon M-Audio
- Mikrofon Hollyland
- Mikrofon PSC
- Mikrofon Microtech Gefell
- Mikrofon Schoeps
- Mikrofon Alto
- Mikrofon Relacart
- Mikrofon Eikon
- Mikrofon Pixel
- Mikrofon GoPro
- Mikrofon Audibax
- Mikrofon Solid State Logic
- Mikrofon Primus
- Mikrofon Mojave
- Mikrofon CKMOVA
- Mikrofon Sanken
- Mikrofon Switchcraft
- Mikrofon Sound Devices
- Mikrofon MILAB
- Mikrofon Prodipe
- Mikrofon Ibanez
- Mikrofon Chord
- Mikrofon Cyber Acoustics
- Mikrofon Austrian Audio
- Mikrofon Louroe Electronics
- Mikrofon Astatic
- Mikrofon Ambient
Nyeste Mikrofon Manualer
10 April 2025
10 April 2025
10 April 2025
10 April 2025
10 April 2025
10 April 2025
9 April 2025
3 April 2025
3 April 2025
3 April 2025