Moultrie Deer Feeder 325 Bruksanvisning

Moultrie Videokamera Deer Feeder 325

Les nedenfor 📖 manual på norsk for Moultrie Deer Feeder 325 (2 sider) i kategorien Videokamera. Denne guiden var nyttig for 34 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 17.5 brukere

Last ned PDF

Side 1/2

Instructions for Deer Feeder 325

Hopper Assembly

THANK YOU for your purchase of the Deer Feeder 325. Please read this sheet before

operating the unit. If you should have any questions about this product or any other

Moultrie

product, please contact us using the information on the back of this sheet.

HOPPER ASSEMBLY INSTRUCTIONS

Flip 325 Hopper Top upside down and assemble with

325 Hopper Bottom.

Make Sure to align the leg sockets of the Top and Bottom

sections when assembling. Improper alignment of the top

and bottom sections can aect performance.

Align holes, insert bolts upwards through each hole. Place

lock washer on bolt, and screw wingnut onto bolt until tight.

Repeat for all bolts.

Note: Failure to properly secure 2 halves can result in leakage.

Slide the three provided angled leg brackets into the hopper

as shown. Fully insert brackets through the leg sockets of the

bottom sections and into the leg sockets of the upper hopper

section. Make sure to insert brackets as far as possible.

Connect Quick-Lock Feeder Kit to assembled hopper as shown.

After lling feeder, install lid by aligning handles with notches

in hopper top. Twist until Lid rests ush against Lid Stop.

Place hopper on its side. Assemble three leg poles using two

leg sections each (if provided, more leg sections may be used;

do not exceed 4 leg sections per leg pole). Install a Leg Pole

on the inside of each of the bent leg brackets. Make sure to

have all leg sections fully inserted, tap them into place if

necessary to ensure connection. With two leg poles against

the ground as shown, carefully stand up the feeder assembly.

11172020 / MFG-15013 • MFG-15010 • MFG-15012 • MFG-15017

Upper Section

Leg Socket

Lower Section

Leg Socket

DO NOT EXCEED

325 LBS OF FEED

Quick-Lock

Feeder Kit

Align lugs and L-slots

Our Service Department will gladly answer any questions you have.

www.moultriefeeders.com/support

Bolt

Lock

Washer

Wingnut

MFG-15013_MFG-15010_MFG-15012_MFG-15017_325 INSERT_Manual_ENG-FRE_11-17-20.indd 1

MFG-15013_MFG-15010_MFG-15012_MFG-15017_325 INSERT_Manual_ENG-FRE_11-17-20.indd 1MFG-15013_MFG-15010_MFG-15012_MFG-15017_325 INSERT_Manual_ENG-FRE_11-17-20.indd 1 11/17/20 1:49 PM

11/17/20 1:49 PM

11/17/20 1:49 PM11/17/20 1:49 PM