Scanstrut SC-CW-03E Bruksanvisning

Scanstrut Ikke kategorisert SC-CW-03E

Les nedenfor 📖 manual på norsk for Scanstrut SC-CW-03E (3 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 14 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Last ned PDF
Side 1/3
1
Drill hole 10mm (25/64”).
2
Place charger and Bezel over hole
to mark screw centres. **Caution**
Do not remove self adhesive
backing from tape, dry t only.
4
Remove self adhesive backing from
charger.
5
7
Install charger into bezel.
Connect wires to 12-24V
supply, ensuring a water-
proof connection. Fuze
appropriately according to
input voltage and current.
8
Screw Bezel to surface.
Remove and mark hole centres in
bezel.
Input voltage range : 10-30V DC (12/24V system)
Input currant max: 1.5A
Output power: 5W (5V, 1A)
Standby current draw: < 0.03W
Certications: Qi, CE, FCC, ROHS
Waterproof rating: IPX6 front and back
READ THE IMPORTANT SAFETY INFORMATION
LEAFLET BEFORE INSTALLING
Tools Required
Power drill
10mm (3/8”) Drill
Alcohol Wipe
1.6mm (1/16”) Drill
Parts List
Charger
x1
x1
Bezel & gasket
Techinical information
x3
x1
3
Drill 3x 1.6mm (1/16”)
pilot holes.
Installation Instructions
ROKK Wireless Charge Bezel (SC-CW-03E)
05-09-18 Issue 6
No6 x 1/2” self tapping screw
6
+
+
SCANSTRI.H-
out
doo
r .
te
chnologies .
ROK
~™
WI RELESS.
SC-CW-0
1 E
SC-CW-02
E
SC-CW-03E
(ENG)
READ
THESE
INSTRUCTIONS
BEFORE
INSTALLING
THE
PRODUCT
(DE)
LESEN
SIE
DIESE
ANLEITUNG
DURCH,
BEVOR
SIE
MIT
DER
INSTALLATION
BEGINNEN
(ES)
LEA
ESTAS
INSTRUCCIONES
ANTES
DE
INSTALAR
EL
PRODUCTO
(FR)
VEUILLEZ
PRENDRE
CONNAISSANCE
DE
CES
INSTRUCTIONS
(IT)
AVANT DE
PROCEDER
A L'
INSTALLATION
(FIN)
LUE
NAMA
OHJEET
ENNEN
TUOTTEEN
ASENTAMISTA
(SWE)
LAS
DESSA
INSTRUKTIONER
INNAN
PRODUKTEN
INSTALLERAS
The product must be installed in accordance with
the
instructions provided. Failure
to
do
so could result in personal injury, damage
to
your
vessel/vehicle and/or product
failure.
Scanstrut recommends installation is carried
out
by
a qualified electrician. No liability
is accepted
for
damage and/or injury caused
by
incorrect installation.
&
WARNING
• This product is
to
be
fitted
to
a 12V DC
or
24V DC battery/power source only.
•The
power
supply must be switched
off
before installation.
• An appropriate fuse
or
circuit breaker must
be
used in-line between
the
battery/
power
source and
the
product.
•Check
for
correct polarity
of
all wiring before switching
the
power
on.
• This product may contain high voltages.
Do
not tamper with the product.
• This product is NOT approved
for
use in hazardous/flammable atmospheres. Do
NOT install in a hazardous/flammable atmosphere e.g. engine rooms.
• Before drilling any holes, ensure
the
area behind
the
mounting location is clear
of
wires, fuel and all other hazardous objects.
• Ensure any holes
cut
will
not
significantly weaken the structure
of
the surface.
•
If
the
product
needs
to
be mounted outside,
it
must
be mounted in a location safely
above
the
waterline, where
it
is
not
at
risk
of
being submerged.
• The
product
cannot charge through a metallic surface .
.&CAUTION
• The
product
is
specifically
for
the
charging
of
Qi
compatible devices.
• The cable must be retained and not interfere with mechanical systems.
• This product contains no user serviceable components. Do NOT attempt
to
repair
or
alter the product in any way.
•The
high friction
top
surface does not ensure
the
device will not slip during extreme
operating environments such as high acceleration and deceleration.
•
If
a phone case which
is
thicker than 3mm is used
the
device may
not
charge.
•When used in a high ambient temperature/direct sunlight
the
product may
temporarily shut down, this is a safety feature
of
the electronics.
•The
IP rating is only valid
if
correctly installed using
the
instructions and on a
perfectly
flat
non-porous smooth surface.
•When selecting a mounting location, avoid places exposed
to
heat-radiating
appliances and poorly-ventilated areas.
EMC
INSTALLATION
GUIDELINES
Scanstrut products conform
to
Electromagnetic Compatibility
(EMC)
regulations,
to
ensure that electromagnetic interference between equipment is minimised.
Correct installation is required
to
ensure
that
electromagnetic interference is
kept
to
a minimum.
It
is advisable
that
the
product is
not
installed within 1
m/3'
to
any vital
safety equipment such as VHF radios, cables and antennas carrying radio signals. The
product should also
not
be
installed less than 2m/6' from the path
of
a radar beam.
WIRING
When extending the cable from
your
battery/power source
to
the
product, ensure there
is
a minimum
of
1
0V
being provided
to
the
product continuously. We recommend a
wire gauge
of
18AWG
(0
.
82mm2)
for
any length
of
cable extension.
This schematic is
to
illustrate how
the
product should be connected
to
a 12V DC
or
24V DC battery/power supply.
ENVIRONMENTAL
PROTECTION
Waste electrical products should
not
be
disposed
of
with household
waste. Please recycle where facilities exist. Check with your Local
Authority
or
retailer
for
recycling advice.

Produkspesifikasjoner

Merke: Scanstrut
Kategori: Ikke kategorisert
Modell: SC-CW-03E

Trenger du hjelp?

Hvis du trenger hjelp med Scanstrut SC-CW-03E still et spørsmål nedenfor, og andre brukere vil svare deg


Ikke kategorisert Scanstrut Manualer

Scanstrut

Scanstrut SC45 Bruksanvisning

2 August 2025
Scanstrut

Scanstrut RA-01 Bruksanvisning

21 Februar 2025
Scanstrut

Scanstrut TP-01 Bruksanvisning

21 Februar 2025
Scanstrut

Scanstrut TB-01 Bruksanvisning

21 Februar 2025
Scanstrut

Scanstrut Scanpod SPH-3I-W Bruksanvisning

31 Januar 2025
Scanstrut

Scanstrut RL-RM Bruksanvisning

31 Januar 2025
Scanstrut

Scanstrut SPT1001 Bruksanvisning

31 Januar 2025
Scanstrut

Scanstrut PTM-R2-SL Bruksanvisning

31 Januar 2025
Scanstrut

Scanstrut RLS-508-404 Bruksanvisning

31 Januar 2025
Scanstrut

Scanstrut APT-F-150-02 Bruksanvisning

29 Januar 2025

Ikke kategorisert Manualer

Nyeste Ikke kategorisert Manualer

Ideal

Ideal 74-032 Bruksanvisning

15 September 2025
Xiaomi

Xiaomi Electric Kettle 2 Lite Bruksanvisning

15 September 2025
Swingline

Swingline Commercial Electric Punch Bruksanvisning

15 September 2025
Tunturi

Tunturi Platinum UB20 Bruksanvisning

15 September 2025
Bosch

Bosch GGP 12V-25 Professional Bruksanvisning

15 September 2025
Xiaomi

Xiaomi Oclean One Bruksanvisning

15 September 2025
Tunturi

Tunturi Cardio Fit D20 Deskbike Console Bruksanvisning

15 September 2025
Bosch

Bosch GKE 18V-15 Professional Bruksanvisning

15 September 2025
Xiaomi

Xiaomi Smart Pet Food Feeder 2 Bruksanvisning

15 September 2025
Bosch

Bosch GRC 12V-60 1/2 SN Professional Bruksanvisning

15 September 2025