Simrad Sensor Bruksanvisning

Les nedenfor 📖 manual på norsk for Simrad Sensor (4 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 17 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 9 brukere

Side 1/4
Sensor Setup Guide
Sensor Setup Guide
| 1
*988-11035-002*
This document describes the setup for the following sensors:
Fluid Level Sensor – tank levels for fuel*, water, gray water, live well, oil, and black water
Fuel Flow Sensor – flow rate measurements of fuel for gasoline powered boats
Fuel Data Manager – fuel used data from fuel flow messages it receives from up to three
Temperature Sensor – temperatures for water*, outside, inside, engine room, cabin, live well,
bait well, refrigeration, and heating system
Thru-Hull Temperature Sensor - temperatures for water*, outside, inside, engine room, cabin,
live well, bait well, refrigeration, and heating system
Speed Sensor – boat speed
Pressure Sensor – pressure data: Engine Boost Pressure, Engine Oil Pressure, Engine Water
Pressure*, Transmission Oil Pressure and Pitot Speed
* Sensor is pre-configured to display this information.
¼Note: The sensor must be installed and connected to the NMEA 2000 network. For installation
and connection information, refer to the installation guide for the sensor.
After the sensor is connected, you can display sensor data. For more information, refer to your
display operating manual.
Sensor Setup
Use the Device Information dialog to set the device name, configure, view sensor data, and
for some sensors calibrate and set alarms.
Select the sensor in the Device List to display the sensor Device Information dialog. The
following example shows selecting the Fluid Level sensor from a Simrad NSS Evo2.

Produkspesifikasjoner

Merke: Simrad
Kategori: Ikke kategorisert
Modell: Sensor

Trenger du hjelp?

Hvis du trenger hjelp med Simrad Sensor still et spørsmål nedenfor, og andre brukere vil svare deg