Uniden UPP 136 Bruksanvisning
Uniden
batteribank
UPP 136
Les nedenfor 📖 manual på norsk for Uniden UPP 136 (4 sider) i kategorien batteribank. Denne guiden var nyttig for 2 personer og ble vurdert med 4.7 stjerner i gjennomsnitt av 1.5 brukere
Side 1/4
- 1 -
Portable Power Bank &
Jump Start Kit
UPP136
USB Output 2
(Charge mobile devices)
DC Output
(12V/16V/19V devices)
POWER Switch
(ON/OFF)
Power Button
(Flashlight & Power Modes)
DC INPUT
(Charge the UPP136)
Flashlight
LED Display
12V Connector
(Jump start)
USB Output 1
(Charge mobile devices)
• 13600mAh Capacity
• Universal 12V clamps
• Supports Engines
< 5.0L Petrol
< 3.0L Diesel
• USB Port 5V/2.1A Port
• LED Flashlight
• Laptop Connector
• AC/DC Chargers
• Resting Discharge
– 20% Loss/Year
• Carrying Case
FEATURES
WHAT’S INCLUDED
• UPP136 portable power unit
• 8 pcs laptop charging connector with charger leads
• 2–1 USB connector (Micro, Mini)
• Smart Jumper Cable adaptor
• 12-15V DC cigarette lighter adaptor (vehicle adaptor)
• 15V/1.0A AC Adaptor
SLIDE ON THE POWER SWITCH BEFORE YOU DO THE
FOLLOWING:
Charge the unit
- Charge the USB device
- Charge DC12V/16V/19V device
- Use the Flashlight
- Use the Air Pump (Not Included)
USING THE UPP136 POWER BANK
CHARGING THE UNIT
1. Use the 240V AC Adaptor to connect the unit to an AC home outlet
or the cigarette lighter adaptor to connect the unit to the vehicle’s
cigarette lighter socket.
2. Slide ON the POWER switch to monitor charging progress on the
screen. The display shows 100% with when charging is complete.
3. Disconnect the UPP136 from the AC adaptor.
To preserve battery life, fully charge the Power Bank every three
months.
CHECK BATTERY CAPACITY
1. Slide ON the POWER switch.
2. Press POWER button without any devices connected to the char-
ger.
3. The number of bars in the battery icon indicate the power in the
battery.
JUMP START A VEHICLE
1. Slide ON the POWER switch and make sure the Power Bank is
fully charged.
2. Turn off all accessories on the vehicle (radio, air conditioner, etc)
3. Connect the jumper cable’s RED clamp to the POSITIVE post of
the vehicle battery.
4. Connect the jumper cable’s BLACK clamp to the NEGATIVE post
of the vehicle battery.
5. Insert the jumper cable connector into the Power Bank’s 12V
connector (under ap). Be sure the connection is solid.
6. Turn the vehicle ignition key for 3 seconds only. If the vehicle
starts:
• Disconnect the jumper cables from the power pack rst, then
disconnect the clamps from the battery.
• Leave the ignition on for a few minutes, then turn off the
vehicle.
• Start the car.
7. If the car does NOT start on the rst try, wait for a minute and try
again.
CHARGING A 5V USB DEVICE (TABLET, CELL PHONE, ETC.)
1. Slide ON the POWER switch. Connect 2-1 USB connector to the
UPP136.
2. Connect your device to either the miniUSB or microUSB cable.
3. The UPP136 begins to charge your device.
TURN ON FLASHLIGHT
1. Slide ON the POWER switch. Press and hold POWER button to
turn on the LED ashlight in steady mode.
2. Press POWER button again to cycle through the 4 modes: Steady,
- 2 - - 3 -
Produkspesifikasjoner
| Merke: | Uniden |
| Kategori: | batteribank |
| Modell: | UPP 136 |
Trenger du hjelp?
Hvis du trenger hjelp med Uniden UPP 136 still et spørsmål nedenfor, og andre brukere vil svare deg
batteribank Uniden Manualer
25 September 2025
batteribank Manualer
- Rigol
- Phoenix Technologies
- Gembird
- Fresh N Rebel
- Belkin
- SereneLife
- BlueBuilt
- LC-Power
- Anker
- Sogo
- Aluratek
- Biltema
- Clas Ohlson
- Pyle
- Xiaomi
Nyeste batteribank Manualer
25 September 2025
25 September 2025
25 September 2025
25 September 2025
25 September 2025
25 September 2025
25 September 2025
25 September 2025
25 September 2025
25 September 2025