Princeton Tec Switch MPLS Bruksanvisning

Les nedenfor 📖 manual på norsk for Princeton Tec Switch MPLS (2 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 21 personer og ble vurdert med 4.6 stjerner i gjennomsnitt av 11 brukere

Side 1/2
Battery installation
1. ARC Rail Installation 2. MOLLE Mount
Slide ARC Rail Adapter into ARC rail to desired position and secure in place with center
anti-slip lock screw. DO NOT OVERTIGHTEN this screw.
Slide clip inside any strap position, pinch MOLLE strap to hook the lower end of the
metal clip onto the strap.
2
3. MICH Mount Installation 4. Picatinny Rail Mount
Back the screw out so the end of screw is ush with metal U-clip. Slide the exposed
U-clip over the bottom edge of your helmet with the metal clip on the inside and the
tighten center slotted screw until it stops.
Remove the center through screw from the side of the Picatinny base mount. Slide Pica-
tinny to desired position and insert side locking screw aligning with any slot in Picatinny
rail and tighten to clamp in place. DO NOT OVERTIGHTEN this screw.
2
5. (ABR) Above Rail Mount
A. If using MPLS ABR on a ballistic helmet, skip to step two. For
use with nonballistic helmets, begin by snapping off unneeded
portion of ABR mount by hand or with a pair of pliers, and
discarding the smaller ‘hook’ portion
Loosen or remove front rail screw, and slide ABR into desired position
beneath rail. Retighten front rail screw.
1a
2a 1b 2b 3b 4b
Select Charge MPLS mount and secure with included machine screws, gently tightening with a Phillips screwdriver. Install Switch/Point onto mount.
1c 2c 3c
POINT / SWITCH
M P L S
MODULAR PERSONAL
LIGHTING SYSTEM
OPERATING AND MAINTENANCE
INSTRUCTIONS

Produkspesifikasjoner

Merke: Princeton Tec
Kategori: Ikke kategorisert
Modell: Switch MPLS

Trenger du hjelp?

Hvis du trenger hjelp med Princeton Tec Switch MPLS still et spørsmål nedenfor, og andre brukere vil svare deg