Ryobi One+ RC18240 Bruksanvisning
Ryobi
Batterilader
One+ RC18240
Les nedenfor 📖 manual på norsk for Ryobi One+ RC18240 (12 sider) i kategorien Batterilader. Denne guiden var nyttig for 4 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere
Side 1/12
RC18240
IMPORTANT!
The product is not intended to be used or cleaned by
persons with reduced physical, sensory, or mental
capabilities, or lack of experience or knowledge, unless
they have been given instructions concerning the safe
use of the product by a person legally responsible for their
safety. They should be supervised while using the product.
Children shall not use, clean, or play with the product,
which when not in use, should be secured out of their
reach.
It is essential that you read the instructions in this manual
before assembling, operating, and maintaining the product.
Subject to technical modications.
Safety, performance, and dependability have been given top
priority in the design of your battery charger.
INTENDED USE
The charger is intended only to charge the compatible
battery packs listed in this manual.
The product is only for indoor use, in dry conditions.
The product is not intended to charge any other type of
battery or be used as a power supply. It should never be
used in explosive or ammable environments.
Do not use the product for any other purpose.
CHARGER SAFETY WARNINGS
■Read all safety warnings and all instructions. Failure
to follow the warnings and instructions may result in
electric shock, fire and/or serious injury.
■Do not recharge primary cells (non-rechargeable).
■The product must not be damp and should never be
used in a damp environment.
■The product is for indoor use only.
■Do not cover any ventilation slots, and provide adequate
ventilation during operation.
■Mains voltage must correspond with the voltage
specifications on the product.
■Before using the product, check that the charger
enclosure, cable, and plug are not damaged. If damage
is found, do not use the product and bring it to an
authorised service centre for repair.
■Do not use the product if it has suffered any heavy shock
or jolting, or if it is damaged in any other way.
■When charging, do not expose the product to sunlight
or other heat source. The recommended temperature
range at charging vicinity is 10° to 25°C.
■Due to the heat generated during charging, do not use
the product on a combustible surface.
■Do not use the product near flammable materials,
such as cloth, packaging materials, paint, spray paint
or aerosols, lubricants, thinners, petrol containers, gas
containers, or gas appliances.
■Never modify, disassemble, or attempt to repair the
product yourself.
■Do not allow the charger or battery packs to become
contaminated with any material that could be conductive,
such as metallic particles from grinding, cutting, or
machining processes.
■Protect the battery contact terminals from metallic
objects to avoid a short circuit, which can cause fire or
explosion.
■Unplug the product from the power socket when it is not
in use or when cleaning it.
■Use only an extension cable that is approved and in
good condition.
■Do not charge battery packs that show signs of leaks.
Dispose of them properly.
■Never charge a damaged battery pack. Replace
damaged battery packs immediately.
■Before every use, examine the supply cord for damage.
If there are signs of damage, it must be replaced by a
qualified person at an authorised service centre to avoid
a hazard.
ADDITIONAL BATTERY SAFETY WARNINGS
To reduce the risk of re, personal injury, and product
damage due to a short circuit, never immerse your tool,
battery pack or charger in uid or allow a uid to ow inside
them. Corrosive or conductive uids, such as seawater,
certain industrial chemicals, and bleach or bleach-containing
products, etc., can cause a short circuit.
WALL MOUNTING
■Carefully select a stable wall for mounting the charger.
Make sure that there is no hindrance to mounting work or
operation. The maximum gross weight of the charger is
approximately 3.23 kg, provide sufficient reinforcement
for the wall if necessary.
■Mount the charger in a vertical or horizontal orientation
only. Install two screws on the wall to mount the charger.
Otherwise, the charger may fall and cause serious injury.
■Check the tightness of the screws on a regular basis.
Make sure that the head of the screws fit properly in
the wall mounting holes to hold the charger firmly in
place. Otherwise, the charger may fall because of loose
screws.
OPERATION
CHARGING THE BATTERY PACK
■Battery packs are shipped in a low charge condition.
Therefore, you should charge them before first use.
If the charger does not charge the battery pack under
normal circumstances, bring both the battery pack and
charger to an authorised service centre.
■Make sure that the power supply is normal household
voltage, 220–240V, 50/60Hz, AC only.
■Make sure that the battery pack latch clicks into place
and that the battery pack is secured in the charger
before charging.
NOTE: When two battery packs are connected to the
charger, they are charged at the same time. The charging
current is equally distributed to the charging ports.
NOTE: When the battery becomes fully charged, the green
LED remains on. It is normal for the battery pack to become
slightly warm to touch while charging.
NOTE: When charging, the charger and battery pack should
be placed in a location where the temperature is more than
10°C but less than 25°C.
CHARGING A COOL BATTERY PACK
1. Insert the battery pack into the charging port. Make sure
that the battery pack latch clicks into place.
2. Connect the product to a power supply.
3. Disconnect the product from the power supply when the
battery pack becomes fully charged.
4. Press the battery pack latches to unlock the battery pack
from the product.
2
Original Instructions
5. Remove the battery pack from the product.
CHARGING A HOT BATTERY PACK
When using a tool continuously, the cells in the battery pack
become hot. A hot battery pack should be allowed to cool
down for approximately 30 minutes before recharging.
MAINTENANCE
■When not using or when cleaning the product, disconnect
it from the power supply and remove the battery pack.
■Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to various types of commercial
solvents. Use clean cloth or soft brush to remove dirt
and dust.
■Do not, at any time, let brake fluids, gasoline, petroleum-
based products, and penetrating oils come in contact
with plastic parts. These products contain chemicals that
can damage, weaken, or destroy plastic.
■Hazardous voltages are present within the product; do
not disassemble.
CLEANING THE CHARGER
■Unplug the charger power cord from the power supply
before cleaning to prevent serious personal injury.
■Clean the charger surface (except labels) using a damp
cloth with a mild detergent.
■Do not use any strong detergents on the plastic housing.
They can be damaged by certain aromatic oils, such as
pine and lemon, and by solvents such as kerosene.
■Moisture can cause a shock hazard. Wipe off any
moisture with a soft dry cloth.
STORAGE
■Store the product in a cool dry place between 10°C and
38°C.
KNOW YOUR PRODUCT
See page 5.
1. Battery port
2. Green LED
3. Red LED
4. Wall mounting holes
5. Operator’s manual
6. Battery pack
SYMBOLS ON THE PRODUCT
V Volts
Direct current
Alternating current
European Conformity Mark
British Conformity Mark
EurAsian Conformity Mark
Ukraine Conformity Mark
Class II equipment
Please read the instructions carefully before
starting the machine.
For indoor use only.
Time-lag fuse 3.15A
Do not dispose of waste electrical and
electronic equipment as unsorted municipal
waste. Waste electrical and electronic
equipment must be collected separately.
Waste light sources have to be removed
from the equipment. Check with your local
authority or retailer for recycling advice
and collection point. According to local
regulations, retailers may have an obligation
to take back waste electrical and electronic
equipment free of charge. Your contribution
to the reuse and recycling of waste electrical
and electronic equipment helps to reduce
the demand of raw materials. Waste
electrical and electronic equipment contain
valuable and recyclable materials, which
can adversely impact the environment and
the human health if not disposed of in an
environmentally compatible manner. Delete
personal data from waste equipment, if any.
SYMBOLS IN THIS MANUAL
Safety alert
Note
Parts or accessories sold separately
Connect to the power supply.
Disconnect to the power supply.
3
Original Instructions
Produkspesifikasjoner
| Merke: | Ryobi |
| Kategori: | Batterilader |
| Modell: | One+ RC18240 |
Trenger du hjelp?
Hvis du trenger hjelp med Ryobi One+ RC18240 still et spørsmål nedenfor, og andre brukere vil svare deg
Batterilader Ryobi Manualer
1 September 2025
31 August 2025
31 August 2025
31 August 2025
31 August 2025
30 August 2025
30 August 2025
30 August 2025
30 August 2025
30 August 2025
Batterilader Manualer
- Batterilader MSW
- Batterilader DeWalt
- Batterilader Hama
- Batterilader Vorago
- Batterilader Fluke
- Batterilader Schwaiger
- Batterilader IKEA
- Batterilader AEG
- Batterilader Navitel
- Batterilader StarTech.com
- Batterilader Kostal
- Batterilader APSystems
- Batterilader Sony
- Batterilader Nitecore
- Batterilader Yamaha
- Batterilader Xiaomi
- Batterilader Venom
- Batterilader Trust
- Batterilader Gys
- Batterilader Husqvarna
- Batterilader Voltcraft
- Batterilader Lindy
- Batterilader Digitus
- Batterilader Panasonic
- Batterilader Shure
- Batterilader Schneider
- Batterilader Delta
- Batterilader Anker
- Batterilader Growatt
- Batterilader EMOS
- Batterilader Deye
- Batterilader Flex
- Batterilader Kenwood
- Batterilader Hitachi
- Batterilader Tripp Lite
- Batterilader Milwaukee
- Batterilader Tryton
- Batterilader Bluetti
- Batterilader Ansmann
- Batterilader Makita
- Batterilader Einhell
- Batterilader Anova
- Batterilader Conceptronic
- Batterilader V-Tac
- Batterilader Emtop
- Batterilader SolaX Power
- Batterilader Valcom
- Batterilader Mophie
- Batterilader Envertec
- Batterilader Celly
- Batterilader Metabo
- Batterilader Dometic
- Batterilader Joy-it
- Batterilader Nedis
- Batterilader Worx
- Batterilader V7
- Batterilader Karma
- Batterilader Hoymiles
- Batterilader Ozito
- Batterilader Xvive
- Batterilader Wallbox
- Batterilader Sven
- Batterilader Craftsman
- Batterilader Manhattan
- Batterilader Jackery
- Batterilader Rocstor
- Batterilader Techno Line
- Batterilader Monacor
- Batterilader Hilti
- Batterilader Monster
- Batterilader Twelve South
- Batterilader Hive
- Batterilader Silverline
- Batterilader Scanstrut
- Batterilader ISDT
- Batterilader Bebob
- Batterilader Yard Force
- Batterilader Huawei
- Batterilader Ventev
- Batterilader PDP
- Batterilader Sungrow
- Batterilader Vimar
- Batterilader Biltema
- Batterilader Mean Well
- Batterilader Hikoki
- Batterilader Xtorm
- Batterilader AVer
- Batterilader Osram
- Batterilader HyperX
- Batterilader Savio
- Batterilader Digipower
- Batterilader Core SWX
- Batterilader Parkside
- Batterilader Apa
- Batterilader Bolt
- Batterilader Watson
- Batterilader HQ Power
- Batterilader Black Decker
- Batterilader EGO
- Batterilader Xblitz
- Batterilader SWIT
- Batterilader IDX
- Batterilader NOCO
- Batterilader Cellular Line
- Batterilader Alogic
- Batterilader SKROSS
- Batterilader Sandberg
- Batterilader Gp Batteries
- Batterilader Kress
- Batterilader Victron Energy
- Batterilader Absina
- Batterilader Awelco
- Batterilader EA Elektro Automatik
- Batterilader Ctek
- Batterilader Jump-N-Carry
- Batterilader Aim TTi
- Batterilader Cramer
- Batterilader Ergotron
- Batterilader Recom
Nyeste Batterilader Manualer
1 September 2025
1 September 2025
1 September 2025
31 August 2025
30 August 2025
30 August 2025
29 August 2025
29 August 2025
29 August 2025
29 August 2025