Tripp Lite IBAR6 HG Bruksanvisning

Les nedenfor 📖 manual på norsk for Tripp Lite IBAR6 HG (12 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 3 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 2 brukere

Side 1/12
1
Owner’s Manual
1111 W. 35th Street, Chicago, IL 60609 USA
773.869.1234 (USA) • 773.869.1212 (International)
www.tripplite.com
Important Safety Instructions
2
Quick Installation
2
Troubleshooting
3
Specifications
4
Warranty & Warranty Registration
4
isobar
®
Model: ISOBAR6ULTRAHG
Special Use Surge Suppressor (120V)
Copyright © 2009 Tripp Lite. All rights reserved. Isobar
®
is a registered trademark of Tripp Lite.
Español
5
Français
9
Warranty
Registration:
register online today for
a chance to win a FREE
Tripp Lite product—
www.tripplite.com/warranty
200906154 93-2911.indd 1 7/8/2009 3:00:16 PM
2
• Useofthisequipmentinlifesupportapplicationswherefailureofthisequipmentcan
reasonablybeexpectedtocausethefailureofthelifesupportequipmentortosignificantly
affectitssafetyoreffectivenessisnotrecommended.Donotusethisequipmentinthe
presenceofaflammableanestheticmixturewithair,oxygenornitrousoxide.
• ThisTrippLiteSurgeSuppressorisnotintendedforuseinpatient-contactapplications.
• Installyoursurgesuppressorindoors,awayfromexcessmoisture,heatanddust.
• Connectyoursurgesuppressortoathree-wire,groundedACpoweroutlet.Donotremove
ormodifythegroundpinofthesurgesuppressor'splug.Donotusetwo-prongadapters
withthesurgesuppressor'splug.
• Yoursurgesuppressordoesnotrequiremaintenance.Donotopenyoursurgesuppressor
foranyreason.Therearenouser-serviceablepartsinside.
Important Safety Instructions
Quick Installation
1
Plug surge suppressor into a
three-wire, grounded 120V
electrical outlet.
Thesurgesuppressorcannotprovidefull
protectionunlessitispluggedintoaproperly
wiredandgroundedoutlet.The
ISOBAR6ULTRAHGfeaturesahospital-
gradeplugandoutlets.Groundingcontinuity
shouldbecheckedperiodically.Grounding
reliabilitycanonlybeachievedwhenthe
ISOBAR6ULTRAHGisconnectedtoan
equivalentgroundedreceptaclemarked
“Hospital-Only”or“Hospital-Grade.
2
Flip surge suppressor’s
ON/OFF switch ON
(switch will light up).
Whenthisswitchislit,itindicatesthatAC
powerisenabledatthesurgesuppressor's
outlets.
Note: The ISOBAR6ULTRAHG comes with a locking
switch cover to prevent accidental shut-off. Simply depress
the cover until you hear it click for locking, and lift again
to unlock.
1
2
These devices feature an internal protection that will disconnect the surge
protective component at the end of its useful life but will maintain power to
the load—now unprotected.
200906154 93-2911.indd 2 7/8/2009 3:00:16 PM
3
Troubleshooting
Quick Installation
3
PROBLEM SOLUTION
Your circuit breaker trips.
YourIsobarisoverloaded.
Unplugsomeequipment.Waitoneminute
whileyourIsobarcools,thenpushthe
circuitbreakerbuttonbackin.
The green “Protection Present”
and/or “Line OK” LED(s) do not
light.
Yourequipmentisnotfullyprotectedagainst
surgesorthereisawiringfaultinyourwall
outlet.
Makesurethatpowerisavailableatthe
walloutlet,thepowerswitchisonandlit,
andtheIsobariscompletelypluggedin.
The red “Fault” LED lights when
you first plug in your Isobar.
Thereisawiringfaultinyourwalloutlet.
(Phasesarereversed,groundismissing,etc.)
Haveaqualifiedelectricianfixthefault
immediately.NOTE:Aloosewalloutlet
maycausethe“Fault”LEDtolight.Your
Isobarwillidentifymostwiringfaults,but
maynotidentifyeverypossibletypeof
fault.
The red “Fault” LED lights after
continued use of your Isobar.
YourIsobarmayhavebeendamagedbya
surge.
Haveaqualifiedelectricianexamineyour
outlettodetermineifafaulthasdeveloped.
Ifnofaultexists,contactTrippLitefor
service.
Equipment plugged into the
Isobar exhibits audio static or
video “snow.
Someequipmentmaybegeneratingelectrical
interference.
Plugyourequipmentintooutletsnot
directlyacrossfromeachotherandplug
equipmentwithheavypowerdraws(suchas
printers)intooutletsawayfrommonitors
andAVequipment.
3
Plug the power cords of your
electrical equipment into your
surge suppressor’s outlets.
DO NOT OVERLOAD the surge protector.
Each outlet can handle up to 15 amps, but
do not exceed a total load of more than 15
amps for all outlets. If the circuit breaker
trips, the outlets will cease to provide
power. Remove overload and depress
circuit breaker to reset.
PremiumsurgesuppressionandIsolatedFilter
Banktechnologyinstantaneouslystop
damagingsurgesandfilterdisruptiveEMI/
RFIlinenoise,eliminatinginterference
betweenconnectedequipment.Yourelectrical
equipmentisnowprotected.
200906154 93-2911.indd 3 7/8/2009 3:00:17 PM

Produkspesifikasjoner

Merke: Tripp Lite
Kategori: Ikke kategorisert
Modell: IBAR6 HG

Trenger du hjelp?

Hvis du trenger hjelp med Tripp Lite IBAR6 HG still et spørsmål nedenfor, og andre brukere vil svare deg




Ikke kategorisert Tripp Lite Manualer

Ikke kategorisert Manualer

Nyeste Ikke kategorisert Manualer