Westinghouse Cava 6355300 Bruksanvisning
Westinghouse
Lampe
Cava 6355300
Les nedenfor 📖 manual på norsk for Westinghouse Cava 6355300 (2 sider) i kategorien Lampe. Denne guiden var nyttig for 30 personer og ble vurdert med 4.5 stjerner i gjennomsnitt av 15.5 brukere
Side 1/2
W-475
102816
MOUNTING AND WIRING INSTRUCTIONS
NOTE: Underwriters Laboratories (UL) does not require all fixtures to have ground wires. These fixtures
meet all UL specifications.
1. Turn off power at fuse box to avoid possible electric shock.
2. Thread mounting screws (A) into universal mounting plate (B) approximately 3/4 inch (see fig. 1).
3. Secure universal mounting plate (B) to outlet box (C) with outlet box screws (D) (if applicable).
4. Identify color coding of fixture wires (see figure 2).
5. Connect the black wire from the fixture with the black wire (live wire) from the outlet box by wire
connector (I), and wrap the wire connector (I) with electrical tape for a more secure connection.
6. Connect the white wire from the fixture with the white wire (neutral wire) from the outlet box by
wire co
nnector (I), and wrap the wire connector (I) with electrical tape for a more secure connection.
7. Partially thread green grounding screw (J) into side hole (K) on universal mounting plate (B) (see
figure 1).
8. Wrap grounding wire from fixture around green grounding screw stem (J) leaving enough excess
wire, then connect the excess grounding wire from the fixture with the grounding wire from outlet
box by wire connector (I) (if applicable), then wrap the wire connector (I) with electrical tape for a
more secure connection.
9. Tighten grounding screw (J). Do not over tighten.
10. Tuck wires inside outlet box (C) (see figure 1).
FIXTURE ASSEMBLY INSTRUCTIONS
Warning: This fixture is for indoor use only.
1. Raise canopy (G) to ceiling, allowing mounting screws (A) to protrude through openings in canopy
(G), and secure into place with cap nuts (L) (see fig. 1).
2. Place glass (F) into holder (M) and secure with thumb screws (N), making sure that the screws are
inside the holes in the side of the glass, not pressing against the side of the glass..
3. Turn power back on at circuit box.
Westinghouse Lighting, Philadelphia, PA 19154-1029, U.S.A. www.westinghouselighting.com
, WESTINGHOUSE, and INNOVATION YOU CAN BE SURE OF are trademarks of Westinghouse Electric Corporation.
Used under license by Westinghouse Lighting. All rights reserved. Made in China
WARNING
Turn off electricity to the mounting site before beginning installation.
Mounting instructions must be followed exactly as shown for the fixture to be safely supported.
CLEANING AND CARE
To clean, wipe fixture with soft cloth. Clean glass with mild soap. Spray from chemical cleaners can discolor the
finish of fixture. Do not use scouring pads, powders, steel wool or abrasive paper to clean this fixture.
NOTE FOR FIXTURES THAT ARE SOLID BRASS:
Your hand-crafted, solid brass lighting fixture has been coated with a durable, baked-on acrylic lacquer which
gives maximum protection against the weather. However, in time the brightness of the brass will tarnish, giving
way to an authentic old-world brass finish. To keep your solid brass fixture looking new for years to come,
regularly apply a good quality, non-abrasive car wax to all metal surfaces, giving the fixture an extra protective
covering.
ORDERING PARTS
Keep this manual for future reference, and in case replacement parts are needed. Available parts can be ordered
from place of purchase. Use exact wording from diagrams when ordering parts.
FIGURE 2.
FIXTURE
WIRES:
Black
HOUSE
WIRES:
Black
(Hot)
HOUSE
WIRES:
White
(Neutral)
HOUSE
WIRES:
Bare
Copper
(Ground)
FIXTURE
WIRES:
Bare
Copper
(Ground)
FIXTURE
WIRES:
White
*NOT SUPPLIED
Line art shown may not exactly match the
fixture enclosed. However, the installation
instructions do apply to this fixture.
FIGURE 1.
GROUND
WIRE
MOUNTING
SCREWS (A)
UNIVERSAL
MOUNTINGPLATE (B)
OUTLET BOX
SCREWS (D)
CORD
LOCK (P)
DISPOSITIF DE
BLOCAGE DU
CORDON (P)
LED DRIVER
BOÎTIER DE
COMMANDE
À LED
*OUTLET
BOX (C)
WIRE
CONNECTORS (I)
SIDE
HOLE (K)
GREEN GROUNDING
SCREW (J)
GLASS (F)
THUMB
SCREWS (N)
CAP NUTS (L)
ECROUS
CAPUCHONS (L)
CANOPY (G) CHAPEAU (G)
STRAIN
RELIEF (O)
SERRE-CÂBLE (O)
HOLDER (M)
FIL DE MISE
A LA TERRE
VIS DE
FIXATION (A)
PLAQUE DE FIXATION
UNIVERSELLE (B)
VIS DE LA BOITE DE
SORTIE DE COURANT (D)
*BOITE DE SORTIE
DE COURANT (C)
CONNECTEURS
DE FIL (I)
TROU
LATERAL (K)
VIS DE MISE A LA
TERRE (VERTE) (J)
VERRE (F)
VIS A CLE (N)
SUPPORT (M)
*NON FOURNI
Il est possible que le dessin illustré ici ne
soit pas la reproduction exacte de l’appareil
d’éclairage contenu dans la boîte.
Les instructions d’installation demeurent
cependant valables.
FIGURE 1.
NOTE: THIS FIXTURE IS SUITABLE FOR USE WITH DIMMABLE SWITCHES, SEE BELOW FOR LIST OF
COMPATIBLE DIMMERS.
Brand Model # DIMMING RATING
Lutron CTCL-153PDH-WH, MACL-153MR-WH, SCL-153PR-WH, 10-100%
TGCL-153PH-WH, DVCL-153P, S-600P
Leviton IPL06, 6674, IPI06, 6631 10-100%
Not recommended for use with motion sensors, light sensors, timers or any other external controls.
WARRANTY INFORMATION
This Westinghouse Lighting Fixture is warranted against defects in material and workmanship for a
period of Five Years from purchase date. This warranty is in lieu of all other warranties expressed or
implied.
This warranty does not cover acts of nature such as lightning damage, or corrosion and discoloration
of components, nor does it cover damages caused through abuse, improper installation, surges in
electric current, or acts of third parties.
This warranty does not cover costs of removing and re-installing the lighting fixture.
If this product fails for any reason covered by this warranty, contact us toll free at 1-888-417-6222.
ASSEMBLY INSTRUCTIONS FOR INDOOR LIGHTING FIXTURE
Congratulations on your Westinghouse purchase. This fixture has been designed to give you many
years of beauty and service. For questions and comments, please visit www.westinghouselighting.
com/contact-us.
NOTE: Carefully unpack fixture and parts. Make sure all parts are included before discarding any
packing materials (see figure 1).
WARNING:
ELECTRICAL SHOCK CAN RESULT IN SERIOUS INJURY.
Read and follow instructions exactly as shown. If instructions are unclear, do not proceed.
Contact a qualified electrician. Read all instructions before beginning. Proper wiring is
essential for safe operation of this fixture. When cutting or drilling into walls or ceilings, do not
damage electrical wiring, gas lines, or water lines. If any of the fixture or wiring components
are damaged, do not install fixture. Return to place of purchase.
For fixtures provided with 75° C or 90° C supply wire warning only. (These warnings are
provided on the U.L. label and on the fixture carton.) Risk of fire. Most dwellings built before
1985 have supply wires rated 60° C. Consult a qualified electrician before installing.
Owner’s Manual
LED Indoor Lighting Fixture
Installation Instructions
Guide d’utilisation
Instructions d’installation
Appareil d’éclairage pour utilisation intérieure avec LED
GARANTIE LIMITÉE DE CINQ ANS
Cet appareil d’éclairage Westinghouse est assorti d’une garantie de 5 ans contre les défauts de
matériaux et de fabrication, qui entre en vigueur à partir de la date d’achat. La présente garantie se
substitue à toute autre garantie expresse ou tacite.
Cette garantie ne porte ni sur les dommages survenant suite à une catastrophe naturelle (telle que la
foudre), ni sur la corrosion ou la décoloration des pièces; la garantie ne porte pas sur les dommages
survenant suite à une utilisation anormale, une installation impropre, une surtension de courant
électrique ou des actes d’un tiers.
Cette garantie ne porte pas sur les frais de démontage et de réinstallation du ventilateur.
Si ce produit ne fonctionne pas, pour une raison quelconque couverte par cette garantie, contactez-
nous gratuitement au numéro suivant : 1-888-417-6222.
MISE EN GARDE: L’ÉLECTROCUTION POURRAIT CAUSER DE GRAVES BLESSURES PERSONNELLES.
Lisez ces instructions et suivez-les exactement comme illustré. En cas de doute, ne commencez
pas l’installation. Consultez un électricien qualifié. Lisez toutes les instructions avant de
commencer l’installation. Un câblage approprié est essentiel au bon fonctionnement de cet
appareil d’éclairage. Lorsque vous faites une entaille ou que vous percez un trou dans un mur
ou un plafond, n’endommagez pas les câbles électriques, les canalisations de gaz ou d’eau. Si
l’un des composants de raccordement ou de l’appareil d’éclairage est endommagé, n’installez
pas cet appareil d’éclairage. Retournez-le à l’endroit où vous l’avez acheté.
Convient uniquement aux appareils comportant un avertissement indiquant que l’appareil
d’éclairage est doté d’un fil supportant une chaleur de 75°C ou 90°C. (Ces avertissements se
trouvent sur l’étiquette U.L. et sur l’emballage de l’appareil d’éclairage.)
LES INSTRUCTIONS D’ASSEMBLAGE DE L’APPAREIL D’ÉCLAIRAGE POUR UTILISATION INTÉRIEURE
Félicitations ! Vous avez acheté un produit de Westinghouse Lighting. Cet appareil d’éclairage a été
conçu pour durer de nombreuses années. Si vous avez des questions ou des commentaires à
nous communiquer, veuillez visiter www.westinghouselighting.com/contact-us.
NOTA : Déballez soigneusement l’appareil d’éclairage et les pièces. Assurez-vous que toutes les pièces
y sont avant de mettre l’emballage au rebut (voir fig. 1).
ADJUSTING LENGTH OF FIXTURE
1. Loosen screws attaching LED driver (white box with wires) to the mounting bracket beneath it.
Remove one screw but leave the other loosely attached. Rotate the driver carefully away from the
cord to allow the cord to slide freely.
2. Loosen the screw in Strain Relief (O) until cord slides easily, being careful not to completely remove
screw. Slide cord up into canopy until the Holder (M) is the correct distance below the canopy.
Carefully coil the excess wire in the canopy, being careful not to allow the wire to knot or create
tight bends (kinks).
3. Tighten the screw in the Strain Relief (O) until cord does not slide, being careful not to over
tighten. Slide cord through one side of Cord Lock (P) until Cord Lock is nearly touching the top of
the strain relief. Slide cord through the other side of the cord lock until it locks in place.
4. Rotate the LED driver back to its original position making sure that the screw aligns with the
proper hole. Tighten both screws attaching driver to bracket.
Produkspesifikasjoner
| Merke: | Westinghouse |
| Kategori: | Lampe |
| Modell: | Cava 6355300 |
Trenger du hjelp?
Hvis du trenger hjelp med Westinghouse Cava 6355300 still et spørsmål nedenfor, og andre brukere vil svare deg
Lampe Westinghouse Manualer
25 Februar 2025
25 Februar 2025
25 Februar 2025
25 Februar 2025
25 Februar 2025
25 Februar 2025
25 Februar 2025
25 Februar 2025
25 Februar 2025
25 Februar 2025
Lampe Manualer
- Vimar
- August
- Olight
- HQ Power
- Ledlenser
- EMOS
- Zhiyun
- Godox
- Perfect Christmans
- Eurolite
- AFX
- Sonneman
- ColorKey
- Hinkley Lighting
- AVM
Nyeste Lampe Manualer
8 April 2025
8 April 2025
6 April 2025
6 April 2025
5 April 2025
5 April 2025
5 April 2025
5 April 2025
5 April 2025
5 April 2025