Fluke i1010 Bruksanvisning

Fluke Ikke kategorisert i1010

Les nedenfor 📖 manual på norsk for Fluke i1010 (7 sider) i kategorien Ikke kategorisert. Denne guiden var nyttig for 8 personer og ble vurdert med 5.0 stjerner i gjennomsnitt av 4.5 brukere

Last ned PDF

Side 1/7

PN 617677 September 1996 Rev. 3, 8/20

Specifications are subject to change without notification.

All product names are trademarks of their respective companies.

Fluke Corporation

P.O. Box 9090

Everett, WA 98206-9090

U.S.A.

Fluke Europe B.V.

P.O. Box 1186

5602 BD Eindhoven

The Netherlands

i410/i1010

AC/DC Current Clamp

Instructions

Go to www.fluke.com to register your Product and find more information.

Safety

A Warning identifies conditions and procedures that are dangerous to the user.

A Caution identifies conditions and procedures that can cause damage to the

Product or the equipment under test.

XW Warning

To prevent possible electrical shock, fire, or personal injury:

• Carefully read all instructions.

• Read all safety information before you use the Product.

• Do not alter the Product and use only as specified, or the

protection supplied by the Product can be compromised.

• Do not use the Product around explosive gas, vapor, or in damp

or wet environments.

• Do not use the Product if it operates incorrectly.

• Use Product-approved measurement category (CAT), voltage,

and amperage rated accessories (probes, test leads, and

adapters) for all measurements.

• Do not exceed the Measurement Category (CAT) rating of the

lowest rated individual component of a Product, probe, or

accessory.

• Comply with local and national safety codes. Use personal

protective equipment (approved rubber gloves, face protection,

and flame-resistant clothes) to prevent shock and arc blast injury

where hazardous live conductors are exposed.

• Before each use, examine the Product. Look for cracks or

missing pieces of the clamp housing or output cable insulation.

Also look for loose or weakened components. Carefully examine

the insulation around the jaws.

• Do not use test leads if they are damaged. Examine the test leads

for damaged insulation and measure a known voltage.

• Do not touch voltages >30 V ac rms, 42 V ac peak, or 60 V dc.

• Do not apply more than the rated voltage, between the terminals

or between each terminal and earth ground.

Produkspesifikasjoner

Merke:	Fluke
Kategori:	Ikke kategorisert
Modell:	i1010
Antall per pakke:	1 stykker
Kabellengde:	1.6 m
Produktfarge:	Red, Yellow
Videoopptaksgrensesnitt:	Bananplugger
Målekategori som støttes:	CAT III
DC-spenning (maks):	600 V