Coast PolySteel 200 Bruksanvisning
Les nedenfor 📖 manual på norsk for Coast PolySteel 200 (1 sider) i kategorien fakkel. Denne guiden var nyttig for 3 personer og ble vurdert med 4.7 stjerner i gjennomsnitt av 2 brukere
Side 1/1
POLYSTEEL 200 INSTRUCTIONS:
BATTERY INSTALLATION:
Turn the tail cap in a counter clock wise dir ectio n to remove t he cap.
Remove the battery car tridge.
Place three AAA batteries into the cartridge in the direction indicated in
the center of the cartridge.
Replace the cartridge in the light in the direction indicated by the arrow
on the cartridge.
Replace the tail cap and turn it clockwise to tighten it until it is com-
pletely closed.
Note: The POLYSTEEL 200 in clam pack packaging comes with batteries
pre-installed.
QUICK CYCLE SWITCH OPERATION:
This flashlight is equipped with COAST’s Quick-Cycle Switch, featuring
high, medium and low beams.
To activate the high mode from the off position, press the on/off switch
until it clicks once, then releases. Press the on/off switch until it clicks a
second time to turn off the light.
To activate the medium mode, press the on/off switch until it clicks a
third time, then release. Press the on/off switch until it clicks a fourth
time to turn off the light.
To activate the low mode, press the on/off switch until it clicks a fifth
time, then release. Press the on/off switch until it clicks a sixth time
to turn off the light.
The light can also be operated in “momentary” mode. Momentary mode
is activated by partially depressing the on/off switch (less pressure
than required for a full click). The momentary switch will cycle the light
through the high and low beam modes.
Any time the light is turned off for more than five seconds, the high/
medium/low cycle will reset, and the high beam will be activated when
the light is turned back on.
PURE BEAM FOCUSING OPTIC:
This flashlight is equipped with COAST’s Pure Beam Focusing Optic that
allows the user to choose between a broad flood beam and a focused
Bulls-Eye Spot beam for long distance illumination.
To adjust the beam into the Bulls-Eye Spot mode, turn the front bezel
of the light clockwise.
To change the beam into the flood light mode, turn the front bezel of the
light counterclockwise.
MAINTENANCE:
The POLYSTEEL 200 is rated IPX8 and submersible to 3 meters for 6
hours. Wipe the external body with a cloth moistened with water or
isopropyl.
POLYSTEEL 200
16-596v01N 1606A
For warranty and distributor information in
your country, visit: www.COASTportland.com
Produkspesifikasjoner
| Merke: | Coast |
| Kategori: | fakkel |
| Modell: | PolySteel 200 |
Trenger du hjelp?
Hvis du trenger hjelp med Coast PolySteel 200 still et spørsmål nedenfor, og andre brukere vil svare deg
fakkel Coast Manualer
30 September 2025
fakkel Manualer
- Milwaukee
- Silva Schneider
- Craftsman
- DeWalt
- Olympia
- Nitecore
- Silverline
- Ryobi
- Olight
- Parkside
- Gorenje
- PCE
- Carson
- Biltema
- Draper
Nyeste fakkel Manualer
5 Oktober 2025
4 Oktober 2025
24 September 2025
23 September 2025
23 September 2025
23 September 2025
23 September 2025
23 September 2025
23 September 2025
21 September 2025